A fluid filtration and clearing technique to assess microleakage associated with three dentine bonding systems

The aims of this in vitro study were to (a) measure fluid flow through teeth restored with one of three dentine bonding systems and a resin composite restoration; (b) measure the distribution of a silver tracer through the same teeth, and make a comparison with fluid flow; and (c) investigate the effect of thermocycling on both measurement types.

Coronal segments of 30 premolars, randomly allocated to three equal groups, were assessed by fluid filtration. Each group was restored with a resin composite restoration in conjunction with Fuji Bond LC (FBLC), Scotchbond Multi-Purpose Plus (SMP+) or Prime&Bond 2.1 (P&B2.1). Fluid filtration rates were measured in the intact crown and then after cavity preparation, conditioning, dentine bonding, restoration and at 2 and 24 h, 1 week and 1 month following restoration. Six specimens from each group were thermocycled at 1 week. After final filtration measurements the specimens were perfused with silver nitrate and cleared before scoring tracer penetration.

No significant differences (P > 0.05) in fluid filtration rates were found amongst the different bonding systems or at any restoration stage. Thermocycling was not associated with any significant (P > 0.05) increase in fluid filtration. Final fluid filtration and tracer distribution showed a weak and not statistically significant correlation (P > 0.05). The penetration of silver stain indicated a failure of the restorations to seal the cavity and demonstrated a possible pathway by which in vivo post-operative sensitivity could occur.

Although not statistically significant, conditioning of the cavity increased the dentinal permeability but this effect was variable. Thermocycling had no statistically significant effect on microleakage.