[New instruments for preparation of the prosthesis socket and primary stability of the acetabular Press-fit cups]

The aim of the present study was to develop surgical instruments necessary to achieve a precisely reamed surface and stable initial fixation. The instruments used to prepare the socket were a gauge-drill guide, a liner for the spigot hole and two spigotted reamers of different design and indentation intended to achieve a precisely reamed surface while preserving subchondral bone. For each reamer we implanted in a synthetic hip model 10 uncemented cups with 2 mm press-fit and loaded at 2.4 kN in the physiological axis (Mod. 8501, Instron, Canton, MA, USA). The micromotion between implant and bone socket was measured using an inductive micrometric measuring system (MultiNCDT-500, Micro-Epsilon, Ortenburg, Germany) and compared with that seen after using conventional instruments. The use of the new reamer of elliptical design significantly reduced the standard deviations of the measured values (p < 0.01 at the ischium and pubis) and also reduced maximum movement (p < 0.01 at the ischium); at the same time, all the components showed overall limited movement (< 150 microns at the ischium, pubis and ilium) under maximum loading (2.4 kN). Manufacturing tolerances, the quality and wear of the instruments, acetabular bone stock and surgical technique all impact on the degree of press-fit obtainable at surgery. The results of our study show that press-fit and initial stability can be optimized by using adequate instruments to prepare the socket.