Osteometry of the mandible performed using dental MR imaging

On cross-sectional and panoramic reformatted images from axial (dental) CT scans of the mandible it may be difficult to identify the inferior alveolar neurovascular bundle (IANB) in patients lacking a clear-cut bony delimitation of the mandibular canal. Dental MR images are comparable to dental CT scans, which directly show the IANB; however, measurements of length may not be reliable owing to susceptibility artifacts and field inhomogeneities in the oral cavity. Therefore, the accuracy of length measurements on dental MR images was compared with that on dental CT scans and direct osteometry.

Dental T1-weighted MR imaging using a high-resolution turbo gradient-echo sequence and dental CT were performed in six anatomic specimens. The axial scans were reformatted as panoramic and cross-sectional reconstructions on a workstation and characteristic cross sections were obtained from all mandibles. The longest axis in the bucco-lingual and apico-basal directions, the distances from the top of the mandibular canal to the top of the alveolar ridge and from the bottom of the mandibular canal to the base of the mandible, and the diameter of the bone cortex at the alveolar ridge were measured with direct osteometry on the cross sections and compared with measurements on corresponding MR and CT reformatted images.

The correlation between direct osteometry and dental MR and CT was strong, except for the bone cortex diameter at the top of the alveolar ridge, where only a moderate correlation was found. Means of comparable length measurements were not significantly different among the three methods.

The accuracy of length measurements in the jaw bones obtained using dental MR is comparable to that of dental CT and is not significantly different from direct osteometry. Thus, dental MR is a potential alternative to CT for dental imaging.