[3-D model analysis of the maxilla of infants with lip-jaw-palate clefts]

For the investigation of three-dimensional morphological changes in the maxilla of children with cleft lip and palate, the use of two-dimensional test analysis is inadequate. Since no standardised three-dimensional method has so far been available, a three-dimensional digital, computer-aided procedure was developed to visualize and metrically analyse the growth of the edentulous maxilla of infants with cleft lip and palate. Chronologically consecutive casts of the maxillas (obtained at the ages of one week, and three, six and twelve months) of five children with complete unilateral CLP were measured optically with the instrument Micromeasure 70. Following digitation, the casts were reconstructed in the computer, aligned and superimposed using the Orthosurf program. The distances between the surfaces were then measured; in addition, the surfaces were segmented perpendicular to the alveolar crest at reference points C1, C1', C2, C2' and I. The volumes of the resulting segments were determined and compare with one another. Specially designed software automated the following steps: 1. identification of reference points; 2. alignment of the cloud of points in a system of coordinates, and 3. identification of the alveolar crest. Our initial results show that (1) the new method enables visualization of the extent and direction of morphological changes of the mucosal surface, and (2) reproducible quantification of these changes via the determination of changes in the volume of defined alveolar segments. The three-dimensional analysis presented here permits a comprehensive three-dimensional measurement of the models of the edentulous maxilla of infants with cleft lip and palate.