Electrical burn of urethra as cause of stricture after transurethral resection

One of the most common complications of transurethral resection is urethral stricture. The exact etiology is still controversial. Postulated pathophysiology ranges from mechanical trauma to the urethra during the resection to inflammatory reaction secondary to local anesthesia. We propose electrical burn to the urethra as a contributory factor in some cases.

Electrical events during transurethral resection were simulated in vitro. The distribution of current was measured at the loop/rollerball and in the outer metal sheath. Both an intact loop/rollerball and loop/rollerball with faulty insulation were tested. Various power outputs simulating coagulation, cutting, and vaporization were used. Data were recorded both in settings where the outer metal sheath was and was not smeared with nonconductive lubricating gel.

Approximately 20% of the total current output was shunted to the metal sheath when an intact loop/rollerball was used. One hundred percent of the current was short-circuited to the sheath when a loop/rollerball with faulty insulation was retracted into the sheath. Little current was detectable in the nonconductive lubricating gel. We then calculated the length of time required, in various settings, to reach tissue temperature of 45 degrees C, when protein denaturation starts. The higher the power output and the smaller the contacting surface area, the more likely it is for urethral burns to occur.

Our in vitro experiment showed that urethral burns secondary to stray current in the resectoscope sheath are unlikely when an intact loop is used. However, urethral burns can occur when a loop/rollerball with faulty insulation is used, especially in combination with nonconductive gel that is dispersed unevenly within the urethra.