Related Experiment Video

Updated: Aug 8, 2026

Removal of Trace Elements by Cupric Oxide Nanoparticles from Uranium In Situ Recovery Bleed Water and Its Effect on Cell Viability

Removal of Trace Elements by Cupric Oxide Nanoparticles from Uranium In Situ Recovery Bleed Water and Its Effect on Cell Viability

Published on: June 21, 2015

Aluminum fractions in drinking water from reservoirs

M Schintu¹, P Meloni, A Contu

¹Dipartimento di Igiene e Sanità Pubblica, Università di Cagliari, Italy, Via Porcell 4, Cagliari, 09100, Italy.

Ecotoxicology and Environmental Safety

|May 12, 2000

Abstract:

To provide insight into aluminum speciation in raw and in finished water and to investigate the factors that can affect it, specific aluminum fractions have been isolated and analyzed in water samples from three drinking water reservoirs in Sardinia (Italy) and at the outlet of their treatment plants. All water treatment plants employed polyaluminum chloride as coagulant. The results demonstrate that the treatment of raw water with the aluminum-based coagulant did not increase the concentration of the metal in the finished water. Aluminum fractions were quite different in raw water and in finished water. More than 80% of the aluminum in raw water was in the particulate form. In the dissolved fraction, organic forms were present at higher concentrations in the raw water, while following water treatment (coagulation, flocculation, filtration) most of the aluminum was in the inorganic form. Most of the dissolved Al in raw water was strongly bound or polymeric colloidal, while percentages of monomeric Al ranging from 40 to 62% were present in the finished water.

More Related Videos

Quantification of Heavy Metals and Other Inorganic Contaminants on the Productivity of Microalgae

Quantification of Heavy Metals and Other Inorganic Contaminants on the Productivity of Microalgae

Published on: July 10, 2015

Hydrogen Charging of Aluminum using Friction in Water

Hydrogen Charging of Aluminum using Friction in Water

Published on: January 28, 2020

Related Concept Videos

Factors Affecting Solubility

Factors Affecting Solubility

Compared with pure water, the solubility of an ionic compound is less in aqueous solutions containing a common ion (one also produced by dissolution of the ionic compound). This is an example of a phenomenon known as the common ion effect, which is a consequence of the law of mass action that may be explained using Le Chȃtelier’s principle. Consider the dissolution of silver iodide:

Qualitative Analysis

Qualitative Analysis

For solutions containing mixtures of different cations, the identity of each cation can be determined by qualitative analysis. This technique involves a series of selective precipitations with different chemical reagents, each reaction producing a characteristic precipitate for a specific group of cations. Metal ions within a group are further separated by varying the pH, heating the mixture to redissolve a precipitate, or adding other reagents to form complex ions.
For instance, group IV...

Precipitation and Co-precipitation

Precipitation and Co-precipitation

Precipitation and coprecipitation methods can be used to separate a mixture of ions in a solution. In qualitative inorganic analysis, ions that form sparingly soluble precipitates with the same reagent are separated based on the differences in solubility products. For example, consider the separation of Cu(II) and Fe(II) ions by precipitation as insoluble sulfides. First, copper(II) sulfide is precipitated by the addition of acidic H2S, where the dissociation of H2S is suppressed. Adding H2S...

Coagulation

Coagulation

Colloidal solids are solid particles suspended in solution. They are usually negatively charged, attracting a compact primary layer of positively charged ions, which attract more counterions to form an electrical double layer. Electrostatic repulsion between the charged double layers prevents the particles from colliding, stabilizing the colloids. These solids are often undesirable because they can contain toxins that are difficult to remove. Coagulation is a technique that helps aggregate and...

Quality of Water

Quality of Water

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...

Acid Mine Drainage

Acid Mine Drainage

Mining activities that disturb sulfide-rich rocks, particularly those containing pyrite (FeS₂), initiate a cascade of geochemical and microbiological processes with serious environmental implications. When exposed to air and water, pyrite undergoes oxidation, releasing sulfate, ultimately forming sulfuric acid and mobilizing heavy metals into surrounding water systems. This phenomenon, known as acid mine drainage (AMD), results in low pH waters laden with toxic elements that threaten aquatic...

Articles linked to this work by shared authors, journal, and citation graph.

First Measurement of the Decay-Time-Integrated CP Asymmetry in B_{s}^{0}→D_{s}^{-}π^{+} Decays.

Physical review letters·2026

Study of Nuclear Effects on Charm Production in Light-Ion Collisions.

Physical review letters·2026

First Evidence of the Decay B^{+}→π^{+}e^{+}e^{-}.

Physical review letters·2026

Search for the Lepton-Flavor Violating Decays B^{+}→π^{+}μ^{±}e^{∓}.

Physical review letters·2026

CP Violation Analysis of Local and Nonlocal Amplitudes in the B[over ¯]^{0}→K[over ¯]^{*0}μ^{+}μ^{-} Decay.

Physical review letters·2026

Evidence for the Rare Decay B^{+}→Λ[over ¯]pμ^{+}μ^{-}.

Physical review letters·2026

See all related articles