Pulsed plasma deposition of allylamine on polysiloxane: a stable surface for neuronal cell adhesion

Allylamine was pulse-plasma polymerized onto a hydrophobic polysiloxane substrate to create cell adhesion surfaces for cell culture that would not require pretreatment with polylysine, could be sterilized via autoclaving, and could be re-used for several culture cycles. We investigated two different plasma deposition protocols at 200 W RF power: (1) a duty cycle of 3 ms on and 5 ms off; and (2) a cycle of 3 ms on and 45 ms off. Control surfaces were unmodified polysiloxane, activated polysiloxane via flaming, and flamed polysiloxane further modified with poly-D-lysine (PDL). The different surfaces were characterized with XPS analysis, water contact angle, and cell adhesion and growth using dissociated murine embryonic spinal tissue. We found that both the amine content of the 3/45 duty cycle surface and the wettability was higher than that of the 3/5 surface. Also, spinal cord cells were better dispersed 24 h after seeding on the 3/45 surface, suggesting a difference in early adhesion dynamics. However, the networks on the two types of modified surfaces revealed no obvious morphological differences after 2 weeks in vitro. The stability of allylamine-decorated surfaces after autoclaving was high with only minor changes in wettability and nitrogen content. Cell growth on such surfaces after autoclaving was comparable to that found on flamed polysiloxane, freshly modified with PDL. Allylamine surfaces were still usable as cell growth substrates after three autoclaving cycles, 4 weeks under warm culture medium, and simple cleaning procedures, indicating the achievement of a long-lasting modification that did not require the repeated use of PDL before each seeding.