Prototyping of masks, masters, and stamps/molds for soft lithography using an office printer and photographic...

This paper describes a practical method for the fabrication of photomasks, masters, and stamps/molds used in soft lithography that minimizes the need for specialized equipment. In this method, CAD files are first printed onto paper using an office printer with resolution of 600 dots/in. Photographic reduction of these printed patterns transfers the images onto 35-mm film or microfiche. These photographic films can be used, after development, as photomasks in 1:1 contact photolithography. With the resulting photoresist masters, it is straightforward to fabricate poly(dimethylsiloxane) (PDMS) stamps/molds for soft lithography. This process can generate microstructures as small as 15 microm; the overall time to go from CAD file to PDMS stamp is 4-24 h. Although access to equipment-spin coater and ultraviolet exposure tool-normally found in the clean room is still required, the cost of the photomask itself is small, and the time required to go from concept to device is short. A comparison between this method and all other methods that generate film-type photomasks has been performed using test patterns of lines, squares, and circles. Three microstructures have also been fabricated to demonstrate the utility of this method in practical applications.