Physical nature of higher-order mutual information: intrinsic correlations and frustration

Matsuda1

  • 1Department of Materials Science, Faculty of Integrated Arts and Sciences, Osaka Prefecture University, Sakai, Osaka 599-8531, Japan.

Related Concept Videos

Correlations02:20

Correlations

Correlation means that there is a relationship between two or more variables (such as ice cream consumption and crime), but this relationship does not necessarily imply cause and effect. When two variables are correlated, it simply means that as one variable changes, so does the other. We can measure correlation by calculating a statistic known as a correlation coefficient. A correlation coefficient is a number from -1 to +1 that indicates the strength and direction of the relationship between...
¹H NMR: Interpreting Distorted and Overlapping Signals01:02

¹H NMR: Interpreting Distorted and Overlapping Signals

Spin systems where the difference in chemical shifts of the coupled nuclei is greater than ten times J are called first-order spin systems. These nuclei are weakly coupled, and their chemical shifts and coupling constant can generally be estimated from the well-separated signals in the spectrum.
As Δν decreases and the signals move closer, the doublets appear increasingly distorted. The intensities of the inner lines increase at the cost of those of the outer lines as the signals are slanted or...
Correlation01:09

Correlation

In statistics, two variables are said to be correlated if the values of one variable are associated with the other variable. Depending on the relationship between two variables, correlation can be of three types– positive correlation, negative correlation, and zero correlation.
Two variables, for example, a and b, are said to be positively correlated if both variables move in the same direction. In other words, a positive correlation exists between two variables, a and b, if:
Coefficient of Correlation01:12

Coefficient of Correlation

The correlation coefficient, r, developed by Karl Pearson in the early 1900s, is numerical and provides a measure of strength and direction of the linear association between the independent variable x and the dependent variable y.
If you suspect a linear relationship between x and y, then r can measure how strong the linear relationship is.
What the VALUE of r tells us:
The value of r is always between –1 and +1: –1 ≤ r ≤ 1.
The size of the correlation r indicates the strength of the linear...
Entropy and the Second Law of Thermodynamics01:20

Entropy and the Second Law of Thermodynamics

The second law of thermodynamics can be stated quantitatively using the concept of entropy. Entropy is the measure of disorder of the system.
The relation  between entropy and disorder can be illustrated with the example of the phase change of ice to water. In ice, the molecules are located at specific sites giving a solid state, whereas, in a liquid form, these molecules are much freer to move. The molecular arrangement has therefore become more randomized. Although the change in average...
Absolute Entropies and the Third Law of Thermodynamics01:23

Absolute Entropies and the Third Law of Thermodynamics

Ludwig Edward Boltzmann developed a definition for entropy, which stated that absolute entropy is proportional to the natural logarithm of the number of possible combinations of particles. Entropy stands alone among state functions as the only one whose absolute values can be determined.Consider a gas sample confined to a container. As the container expands, the energy levels of gas molecules become more closely spaced. This increases the number of available energy states, thereby increasing...