Color and chlorinated organics removal from pulp mills wastewater using activated petroleum coke

Delayed petroleum coke, a waste by-product from the oil sand industry, was utilized in the production of activated carbon. The activated carbon was then evaluated for color and chlorinated organics reduction from pulp mill wastewater. The activation of the petroleum coke was evaluated using a fixed bed reactor involving carbonization and activation steps at temperature of 850 degrees C and using steam as the activation medium. The activation results showed that the maximum surface area of the activated coke was achieved at an activation period of 4 h. The maximum surface area occurred at burnoff and water efficiency of 48.5 and 54.3%, respectively. Increasing the activation period to 6 h resulted in a decrease in the surface area. Methylene blue adsorption results indicated that the activation process was successful. Methylene blue adsorbed per 100 g of applied activated coke was 10 times higher than that adsorbed by raw petroleum coke. Adsorption equilibrium results of the bleached wastewater and the activated coke showed that significant color, COD, DOC and AOX removal (> 90%) was achieved when the activated coke dose exceeded 15,000 mg/L. Adsorption isotherms, in terms of COD, DOC, UV and color were developed based on the batch equilibrium data. Based on these isotherms, the amount of activated coke required to achieve certain removal of color and AOX can be predicted. The utilization of the petroleum coke for the production of activated carbon can provide an excellent disposal option for the oil sand industry at the same time would provide a cheap and valuable activated carbon.