A method for investigating the mechanical properties of intracoronary stents using finite element numerical...

The proliferation of stent designs poses difficult problems to clinicians, who have to learn the relative merits of all stents to ensure optimal selection for each lesion, and also to regulatory authorities who have the dilemma of preventing the inappropriate marketing of substandard stents while not denying patients the benefits of advanced technology. Of the major factors influencing long-term results, those of patency and restenosis are being actively studied whereas the mechanical characteristics of devices influencing the technical results of stenting remain under-investigated. Each different stent design has its own particular features. A robust method for the independent objective comparison of the mechanical performance of each design is required. To do this by experimental measurement alone may be prohibitively expensive. A less costly option is to combine computer analysis, employing the standard numerical technique of the finite element method (FEM), with targeted experimental measurements of the specific mechanical behaviour of stents. In this paper the FEM technique is used to investigate the structural behaviour of two different stent geometries: Freedom stent geometry and Palmaz-Schatz (P-S) stent geometry. The effects of altering the stent geometry, the stent wire diameter and contact with (and material properties of) a hard eccentric intravascular lesion (simulating a calcified plaque) on stent mechanical performance were investigated. Increasing the wire diameter and the arterial elastic modulus by 150% results in the need to increase the balloon pressure to expand the stent by 10-fold. Increasing the number of circumferential convolutions increases the pressure required to initiate radial expansion of mounted stents. An incompressible plaque impinging on the mid portion of a stent causes a gross distortion of the Freedom stent and an hour-glass deformity in the P-S stent. These findings are of relevance for future comparative studies of the mechanical performance of stents, in designing newer stents and also in clinical practice.