Diffusion mechanism of chloride ions in sodium montmorillonite

For safety assessment of geological disposal of HLW, it is necessary to understand the diffusion mechanism of radionuclides in compacted bentonite. In this study, the diffusion behavior of chloride ions in compacted montmorillonite was studied from the viewpoints of the activation energy for apparent diffusion and the basal spacing of the compacted montmorillonite. A unique change in the activation energy as a function of the dry density of the montmorillonite was found. The activation energy decreased from 17.4 to 13.5 kJ mol-1 as the dry density increased from 0.7 to 1.0 Mg m-3 and increased to 25.1 kJ mol-1 at dry densities above 1.0 Mg m-3. The basal spacing of 1.88 nm, corresponding to the three-water layer hydrate state, was not observed by X-ray diffraction (XRD) until the dry density increased to 1.0 Mg m-3, where the minimum activation energy was obtained. On the other hand, a basal spacing of 1.56 nm, corresponding to the two-water layer hydrate state, was observed at the dry densities of 1.4 Mg m-3 and above, where the activation energies were more than 22 kJ mol-1. These experimental results suggest that there are at least two additional diffusion processes that can raise or reduce the activation energy and are affected by water in the region adjacent to the montmorillonite surfaces. If the "Grahame model" can be introduced to describe the electrical double layer, surface diffusion will be considered the possible predominant diffusion process, even for anions like chloride ions.