Effects of cell surface damage on surface properties and adhesion of Pseudomonas aeruginosa

Bacterial cell surfaces play a crucial role in their adhesion to surfaces. In the present study, physico-chemical cell surface properties of Pseudomonas aeruginosa, isolated from a case of contact lens associated keratitis, are determined for mid-exponential and early stationary phase cells and for cells after exposure to a lens care solution or after mechanical damage by sonication. Exposure to a lens care solution and mechanical cell surface damage reduced the cell surface hydrophobicity and water contact angles decreased from 129 degrees to 96 degrees and 83 degrees, respectively. Zeta potentials in saline (-9 mV) were hardly affected after mechanical damage, but tri-modal zeta potential distributions, with subpopulation zeta potentials at -11, -28 and -41 mV, were observed after exposure of bacteria to a lens care solution. X-ray photoelectron spectroscopy indicated changes in the amounts of oxygen-, nitrogen- and phosphorus-rich cell surface components. Mid-exponential phase cells had more nitrogen-rich cell surface components than early stationary phase cells, but water contact angles and zeta potentials were not very different. In addition, mid-exponential phase cells adhered better than early stationary phase cells to hydrophobic and hydrophilic substrata in a parallel plate flow chamber. The capacity of P. aeruginosa to adhere was decreased after inflicting cell surface damage. Exposure to a lens care solution yielded a larger reduction in adhesion capacity than sonication, likely because sonication left most of the cells in a viable state, in contrast to exposure to a lens care solution. It is argued that for clinically relevant experiments, it may be preferable to work with surface damaged cells rather than with gently harvested organisms.