Using CCM for the Prediction of Sorption Curves under Varying Ionic Strength Conditions: Reply to Some Comments

The free energy change associated with dissolving a solute in a liter of solvent is called the free energy of a solution, ΔGsolution. The overall ΔGsolution is expressed as the balance of ΔGinteraction against the always-favorable free-energy of mixing, ΔGmixing. Solution formation is favorable if  ΔGsolution is less than zero, whereas it is unfavorable if ΔGsolution is greater than zero. In short, for a solution to form and complete dissolution to take place, the Gibbs energy change must be...

Solubility equilibria are established when the dissolution and precipitation of a solute species occur at equal rates. These equilibria underlie many natural and technological processes, ranging from tooth decay to water purification. An understanding of the factors affecting compound solubility is, therefore, essential to the effective management of these processes. This section applies previously introduced equilibrium concepts and tools to systems involving dissolution and precipitation.
The...

Brunauer, Emmett, and Teller (BET) introduced a theory in 1938 that modified Langmuir's assumptions to explain multilayer physical adsorption. This theory is applicable to Type II isotherms and provides a more realistic picture of adsorption processes. The BET theory assumes a uniform solid surface with localized adsorption sites, where adsorption at one site doesn't affect adsorption at neighboring sites. This theory also allows for the possibility of additional molecules being adsorbed on top...

Ion-exchange chromatography, or IEC, is a technique for separating ions based on their affinity for the stationary phase. The stationary phase is a cross-linked polymer resin with covalently attached ionic functional groups. The functional groups can be either positively charged (cation exchangers) or negatively charged (anion exchangers). A cation exchanger consists of a polymeric anion and active cations, while an anion exchanger is a polymeric cation with active anions. The choice of...

Adsorption isotherms are mathematical models that describe how molecules in a gas or liquid phase interact with surfaces. Two of the most common isotherm models are the Langmuir and Freundlich isotherms, which relate to Type I monolayer chemisorption. The Langmuir model is based on four key assumptions:• Adsorption cannot exceed monolayer coverage.• All surface sites are equivalent.• Molecules adsorb only at vacant sites.• There are no interactions between adsorbed molecules.Consider the...

Solubility is the measure of the maximum amount of solute that can be dissolved in a given quantity of solvent at a given temperature and pressure. Solubility is usually measured in molarity (M) or moles per liter (mol/L). A compound is termed soluble if it dissolves in water.