Related Experiment Video
Updated: Jun 26, 2026

Cellular Lipid Extraction for Targeted Stable Isotope Dilution Liquid Chromatography-Mass Spectrometry Analysis
Published on: November 17, 2011
Total synthesis of epothilone B, epothilone D, and cis- and trans-9,10-dehydroepothilone D
J D White1, R G Carter, K F Sundermann
1Department of Chemistry, Oregon State University, Corvallis, OR 97331-4003, USA.
Abstract:
The phosphonium salt 35, representing one of the two principal subunits of the epothilones, was prepared from propargyl alcohol via heptenone 22. A Wittig reaction of the phosphorane from 35 with aldehyde 33, obtained from aldol condensation of ketone 27 with aldehyde 28, afforded 37. Seco acid 42 derived from 37 underwent lactonization to give cis-9,10-dehydroepothilone D (43) which was selectively reduced with diimide to yield epothilone D (4) and, after epoxidation, epothilone B (2). An alternative route to epothilone D employed alkyne 39, obtained from 33, in a Castro-Stephens reaction with allylic bromide 34 to furnish enyne 40. The latter was semi-hydrogenated to provide 37. Alkyne 46, prepared from alcohol 45, was converted to trans-vinylstannane 47 which, in a Stille coupling with allylic chloride 50, gave 51. Seco acid 52 derived from 51 underwent lactonization to give trans-9,10-dehydroepothilone D (54). Bioassay data comparing the antiproliferative activity and tubulin polymerization of 43 and 54 with epothilone B (2), epothilone D (4), and paclitaxel (7) showed that the synthetic analogues were less potent than their natural counterparts, although both retain full antiproliferative activity against a paclitaxel-resistant cell line. No significant difference in potency was noted between cis analogue 43 and its trans isomer 54.
Related Concept Videos
Structure and Nomenclature of Ethers
Ethers are organic compounds with an ether functional group which is characterized by an oxygen atom connected to two — identical or different — alkyl, aryl, or vinyl groups. The C–O–C linkage in dimethyl ether — the simplest ether — has an approximately tetrahedral bond angle of 110.3 degrees. The oxygen atom is sp3- hybridized, with the C–O distance being about 140 pm.
Classification of Ethers
Based on their attached substituent groups, ethers can be classified into two...
Disubstituted Cyclohexanes: cis-trans Isomerism
In cyclohexane, the substituents can occupy different positions generating distinct isomers.
Physical Properties of Ethers
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
Structure and Nomenclature of Epoxides
Preparation of Epoxides
Epoxides result from alkene oxidation, which can be achieved by a) air, b) peroxy acids, c) hypochlorous acids, and d) halohydrin cyclization.
Epoxidation with Peroxy Acids
Epoxidation of alkenes via oxidation with peroxy acids involves the conversion of a carbon–carbon double bond to an epoxide using the oxidizing agent meta-chloroperoxybenzoic acid, commonly known as MCPBA. Since the O–O bond of peroxy acids is very weak, the addition of electrophilic oxygen of peroxy acids to...
Structure of Conjugated Dienes
Conjugated dienes are compounds characterized by the presence of alternating double and single bonds. In a conjugated system like 1,3-butadiene, the unhybridized 2p orbital on each carbon overlaps continuously, allowing the π electrons to be delocalized across the entire molecule. In contrast, this type of overlap does not occur in cumulated and isolated dienes, such as 2,3-pentadiene and 1,4-pentadiene, respectively. Instead, the π electrons remain localized between the double...

