Evaluation of two lead-based paint removal and waste stabilization technology combinations on typical exterior...

A study was conducted to demonstrate the effectiveness of a wet abrasive blasting technology to remove lead-based paint from exterior wood siding and brick substrates as well as to evaluate the effectiveness of two waste stabilization technologies to stabilize the resulting blast media (coal slag and mineral sand) paint debris thereby reducing the leachable lead content. The lead-based paint removal technology effectiveness was determined by the use of an X-ray fluorescence (XRF) spectrum analyzer (L- and K-shell). The effectiveness of the technologies to stabilize the debris was evaluated through the toxicity characteristic leaching procedure (TCLP). Wet abrasive blasting effectively removed the lead-based paint coating from both the wood and brick substrates to below the US Department of Housing and Urban Development Guideline (1mg/cm(2)) with no minimal or no damage to the underlying substrates (P<0.0001). The mean area air levels of lead-containing particulate generated during paint removal were significantly below the personal exposure limit (PEL) (P<0.0001). However, the mean personal breathing zone lead levels were approximately three times higher than the PEL. Neither of the two stabilization technologies consistently stabilized the resultant paint debris to achieve a leachable lead content below the RCRA regulatory threshold of <5 mg/l.