Effects of tension direction on strength of tendon repair

We investigated changes of tensile strength in tendon repair according to tension direction. Thirty-six fresh-frozen digital flexor tendons were divided into 4 groups with 9 tendons each. The tendons were repaired by the modified Kessler method. Sutured tendons were pulled against pulleys at angles of 0 degrees, 30 degrees, 60 degrees, and 90 degrees to the direction of the pull of the testing machine in the 4 groups, respectively. The repaired tendons were tested in a tensile machine to determine 2-mm gap formation force and ultimate strength of the tendons. The 2-mm gap formation force and ultimate strength in the tendons pulled at 0 degrees were statistically higher than those in the tendons pulled at 30 degrees, 60 degrees, and 90 degrees. The 2-mm gap formation force of the tendons pulled at 30 degrees, 60 degrees, and 90 degrees was 86% +/- 10%, 73% +/- 9%, and 64% +/- 8% of that at 0 degrees, respectively. Ultimate strength of tendons pulled at 30 degrees, 60 degrees, and 90 degrees was 89% +/- 9%, 82% +/- 11%, and 76% +/- 8% of that at 0 degrees, respectively. Values of the 2-mm gap formation force and ultimate strength were statistically the lowest in the group with a pulling angle of 90 degrees. There was no statistically significant difference in repair strength between tendons tested at 0 degrees and those in the model without pulleys. The strength of tendon repair changed considerably according to direction of tension added to the tendons. The gap formation force and ultimate strength decreased as angles of tension increased. The results imply that a repaired tendon will be weakened as the finger is increasingly flexed. The decrease in repair strength should therefore be considered in planning a tendon suture to tolerate active finger flexion and a tendon motion protocol after primary tendon repair.