Related Experiment Video

Updated: Oct 3, 2026

Optimized Procedure for Determining the Adsorption of Phosphonates onto Granular Ferric Hydroxide using a Miniaturized Phosphorus Determination Method
08:21

Optimized Procedure for Determining the Adsorption of Phosphonates onto Granular Ferric Hydroxide using a Miniaturized Phosphorus Determination Method

Published on: May 18, 2018

Determination of phosphorus based on the formation of a reduced keggin-type 12-molybdophosphate complex in an

T Ueda1, M Hojo, K Shimizu

  • 1Department of Material Science, Faculty of Science, Kochi University, Japan. chuji@cc.kochi-u.ac.jp

Analytical Sciences : the International Journal of the Japan Society for Analytical Chemistry
|January 11, 2002
PubMed

More Related Videos

High-Throughput Measurement and Classification of Organic P in Environmental Samples08:58

High-Throughput Measurement and Classification of Organic P in Environmental Samples

Published on: June 8, 2011

Assaying for Inorganic Polyphosphate in Bacteria07:20

Assaying for Inorganic Polyphosphate in Bacteria

Published on: January 21, 2019

Related Concept Videos

Experimental Determination of Chemical Formula02:37

Experimental Determination of Chemical Formula

The elemental makeup of a compound defines its chemical identity, and chemical formulas are the most concise way of representing this elemental makeup. When a compound’s formula is unknown, measuring the mass of its constituent elements is often the first step in determining the formula experimentally.
The Phosphorus Cycle01:21

The Phosphorus Cycle

Unlike carbon, water, and nitrogen, phosphorus is not present in the atmosphere as a gas. Instead, most phosphorus in the ecosystem exists as compounds, such as phosphate ions (PO43-), found in soil, water, sediment and rocks. Phosphorus is often a limiting nutrient (i.e., in short supply). Consequently, phosphorus is added to most agricultural fertilizers, which can cause environmental problems related to runoff in aquatic ecosystems.
Gravimetry: Inorganic And Organic Precipitating Agents00:49

Gravimetry: Inorganic And Organic Precipitating Agents

In gravimetry, the precipitant is chosen carefully to obtain a pure solid that can be easily filtered. Common inorganic precipitants can be used to determine several cations and anions. In some cases, the formation of the same precipitate can be used to determine the cation and the anion. For example, the reaction of barium and chromate ions to give barium chromate is used to determine both barium and chromate. However, precipitates such as hydroxides, oxalates, and metal ammonium phosphates...
Titration of a Polyprotic Acid02:08

Titration of a Polyprotic Acid

A polyprotic acid contains more than one ionizable hydrogen and undergoes a stepwise ionization process. If the acid dissociation constants of the ionizable protons differ sufficiently from each other, then the titration curve for such polyprotic acid generates a distinct equivalence point for each of its ionizable hydrogens. Therefore, titration of a diprotic acid results in the formation of two equivalence points, whereas the titration of a triprotic acid results in the formation of three...
Factors Affecting Solubility04:01

Factors Affecting Solubility

Compared with pure water, the solubility of an ionic compound is less in aqueous solutions containing a common ion (one also produced by dissolution of the ionic compound). This is an example of a phenomenon known as the common ion effect, which is a consequence of the law of mass action that may be explained using Le Chȃtelier’s principle. Consider the dissolution of silver iodide:
Photoluminescence: Applications01:14

Photoluminescence: Applications

Photoluminescence offers a wide range of applications due to its inherent sensitivity and selectivity. This technique allows for both direct and indirect analyses of the analyte. Direct quantitative analysis is possible when the analyte exhibits a favorable quantum yield for fluorescence or phosphorescence. However, an indirect analysis may be feasible if the analyte is not fluorescent or phosphorescent, or if the quantum yield is unfavorable. Indirect methods include reacting the analyte with...