Related Experiment Video
Updated: Oct 2, 2026

Determination of the Gas-phase Acidities of Oligopeptides
Published on: June 24, 2013
Experimental validation of Gaussian-3 lithium cation affinities of amides: implications for the gas-phase lithium
Yuet Tsang1, Fung Ming Siu, Ngai Ling Ma
1Department of Applied Biology and Chemical Technology and Central Laboratory of the Institute of Molecular Technology for Drug Discovery and Synthesis, Hong Kong Polytechnic University, Hung Hom, Hong Kong.
Abstract:
Using a refined Gaussian-3 (G3) protocol, the highest level of ab initio calculations reported so far, we have established the Li+ cation binding enthalpy (affinity) at 0 K (in kJ mol-1) for formamide (195.7), N-methylformamide (209.2), N,N'-dimethylformamide (220.0), acetamide (211.7), N-methylacetamide (222.5), and N,N'-dimethylacetamide (230.1), with an estimated maximum uncertainty of +/-8 kJ mol-1. With these six theoretical lithium cation binding affinities as reference values, the absolute Li+ affinities of imidazole and dimethoxyethane were determined by the extended kinetic method, and by adopting the statistical data treatment protocol recently proposed by Armentrout. The Li+ affinities obtained for these two ligands are in good agreement (within 6 kJ mol-1) with recent values determined by the threshold collision-induced dissociation method, and consistent with the Li+ basicity values first reported by Taft and co-workers in 1990. Our study confirms that the previously suggested, and recently implemented, downward revision of Taft's original basicity scale by 10.9 kJ mol-1 is justified for ligands with revised basicities less than 151 kJ mol-1. However, for selected ligands with Li+ basicities greater than 151 kJ mol-1, including some of the six amides studied in this work, the reported discrepancy between theoretical and experimental estimates in the revised Li+ basicity scale of Burk et al. is likely to arise from experimental uncertainties.
More Related Videos
09:45A Protocol for Safe Lithiation Reactions Using Organolithium Reagents
Published on: November 12, 2016
11:04Ion Mobility-Mass Spectrometry Techniques for Determining the Structure and Mechanisms of Metal Ion Recognition and Redox Activity of Metal Binding Oligopeptides
Published on: September 7, 2019
Related Concept Videos
Basicity of Heterocyclic Aromatic Amines
Basicity of Aliphatic Amines
To measure the basicity of amines, two conventions are generally used. The first defines Kb as the basicity constant for the deprotonation reaction of water by the amine, as presented in Figure 1. Conventionally, lower Kb indicates higher...
Basicity of Aromatic Amines
Amides to Amines: LiAlH4 Reduction
Amide reduction requires two equivalents of the reducing agent, acting as a source of hydride ions. As shown in the figure, the reaction is initiated with a nucleophilic attack by the hydride ion at the carbonyl carbon to form a tetrahedral intermediate.
Acid Halides to Ketones: Gilman Reagent
As shown below, the mechanism proceeds in two steps. First, one of the alkyl groups of the reagent acts as a nucleophile and attacks the acyl carbon of the acid chloride to form a tetrahedral intermediate. This is followed by the reformation of the carbon–oxygen double...
Acidity of 1-Alkynes
The acidic strength of hydrocarbons follows the order: Alkynes > Alkenes > Alkanes. The strength of an acid is commonly expressed in units of pKa — the lower the pKa, the stronger the acid. Among the hydrocarbons, terminal alkynes have lower pKa values and are, therefore, more acidic. For example, the pKa values for ethane, ethene, and acetylene are 51, 44, and 25, respectively, as shown here.