[The influence of water immersion on the course of labor]

J Moneta1, A Oknińska, M Wielgoś

  • 1I Klinice Połoznictwa i Ginekologii AM w Warszawie.

Ginekologia Polska
|March 9, 2002
PubMed

Related Concept Videos

Handwashing II: Pre-procedure and Initial Procedure Steps01:19

Handwashing II: Pre-procedure and Initial Procedure Steps

The pre-procedure steps of handwashing include removing jewelry and rolling up sleeves. However, many organizations allow staff to wear wedding rings.
The hand washing procedure itself includes the following steps. First, cover cuts, if any, on hands with a waterproof dressing. Cuts and abrasions can become contaminated with bacteria hindering the ability to clean the area thoroughly. In addition, repeated hand washing can worsen an injury.  The nails must be short and clean, without nail paint...
Local Anesthetics: Clinical Application as Epidural Anesthesia01:29

Local Anesthetics: Clinical Application as Epidural Anesthesia

Epidural anesthetics are administered in the fat-filled epidural space, the outermost part of the spinal canal. This technique is commonly employed for pain management and anesthesia during lower abdomen and pelvis surgeries or labor and delivery.
Since epidural anesthetics can be infused through an epidural catheter, all types of drugs, including short-acting ones, can be administered. Chloroprocaine and lidocaine are examples of short and long-duration anesthetics, respectively. Bupivacaine...
Porosity and Absorption of Aggregate01:20

Porosity and Absorption of Aggregate

Aggregates contain pores of varying sizes; while some are completely enclosed within the particles, others open onto the surface, allowing water to penetrate. The porosity of aggregates is a major factor contributing to the overall porosity of concrete, given that aggregates constitute about three-quarters of concrete's volume.
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the aggregate...
Testing Water Quality01:14

Testing Water Quality

When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...
Factors Affecting Workability01:24

Factors Affecting Workability

The workability of concrete is a critical characteristic that influences the ease of mixing, handling, and finishing the concrete. It is affected by several factors including water content, aggregate properties, and admixtures like air entrainment. Water plays a fundamental role as it lubricates the concrete mix, facilitating easier movement and placement. However, the water requirement varies depending on the texture and shape of aggregates. Finer particles and angular, rough-textured...
Development of the Oral Microbiota01:28

Development of the Oral Microbiota

The establishment of the oral microbiome begins before birth, challenging the long-held belief that the fetal oral cavity is sterile. The presence of oral microbes such as Streptococcus and Fusobacterium in amniotic fluid suggests that microbial exposure may occur in utero, potentially through translocation from the maternal oral or gastrointestinal tract. This early colonization primes the neonatal immune system and sets the stage for subsequent microbial succession. Maternal health,...