Related Experiment Video
Updated: Aug 9, 2026

A Method to Test the Efficacy of Handwashing for the Removal of Emerging Infectious Pathogens
Published on: June 7, 2017
Risk assessment of hand washing efficacy using literature and experimental data
Rebecca Montville1, Yuhuan Chen, Donald W Schaffner
1Food Risk Analysis Initiative, Department of Food Science, Rutgers--the State University of New Jersey, New Brunswick 08901-8520, USA.
Abstract:
This study simulated factors that influence the levels of bacteria on foodservice workers' hands. Relevant data were collected from the scientific literature and from laboratory experiments. Literature information collected included: initial bacterial counts on hands and water faucet spigots, bacterial population changes during hand washing as effected by soap type, sanitizing agent, drying method, and the presence of rings. Experimental data were also collected using Enterobacter aerogenes as a surrogate for transient bacteria. Both literature and experimental data were translated into appropriate discrete or probability distribution functions. The appropriate statistical distribution for each phase of the hand washing process was determined. These distributions were: initial count on hands, beta (2.82, 2.32, 7.5); washing reduction using regular soap, beta (3.01, 1.91, -3.00, 0.60); washing reduction using antimicrobial soap, beta (4.19, 2.99, -4.50, 1.50); washing reduction using chlorhexidine gluconate (CHG), triangular (-4.75, -1.00, 0); reductions from hot air drying, beta (3.52, 1.92, -0.20, 1.00); reduction from paper towel drying, triangular (-2.25, -0.75, 0); reduction due to alcohol sanitizer, gamma (-1.23, 4.42) -5.8; reduction due to alcohol-free sanitizer, gamma (2.22, 5.38) -5.00; and the effect of rings, beta (8.55, 23.35, 0.10, 0.45). Experimental data were fit to normal distributions (expressed as log percentage transfer rate): hand-to-spigot transfer, normal (-0.80, 1.09); spigot to hand, normal (0.36, 0.90). Soap with an antimicrobial agent (in particular, CHG) was observed to be more effective than regular soap. Hot air drying had the capacity to increase the amount of bacterial contamination on hands, while paper towel drying caused a slight decrease in contamination. There was little difference in the efficacy of alcohol and alcohol-free sanitizers. Ring wearing caused a slight decrease in the efficacy of hand washing. The experimental data validated the simulated combined effect of certain hand washing procedures based on distributions derived from reported studies. The conventional hand washing system caused a small increase in contamination on hands vs. the touch-free system. Sensitivity analysis revealed that the primary factors influencing final bacteria counts on the hand were sanitizer, soap, and drying method. This research represents an initial framework from which sound policy can be promulgated to control bacterial transmission via hand contacts.
Related Concept Videos
Healthcare Associated Infections II: Preventive Measures
The best practices for preventing healthcare-associated infections include hand hygiene, patient risk...
Hand hygiene
Hand washing...
Handwashing I: Introduction and Types of Equipment
Hand wash basins in clinical areas should have faucets that can be turned on and off without using the hands; that is, they should be non-touch or lever-operated.
Handwashing II: Pre-procedure and Initial Procedure Steps
The hand washing procedure itself includes the following steps. First, cover cuts, if any, on hands with a waterproof dressing. Cuts and abrasions can become contaminated with bacteria hindering the ability to clean the area thoroughly. In addition, repeated hand washing can worsen an injury. The nails must be short and clean, without nail paint...
Handwashing III: During the Procedure and Post-Procedure Steps
Antimicrobial Effectiveness

