Fluid bed granulation of a poorly water soluble, low density, micronized drug: comparison with high shear granulation

A 2(4-1) fractional factorial design was used to evaluate the effect of various process variables in fluid bed granulation, on the physico-chemical properties of granule and tablet containing a high dose, poorly water soluble, low density, and micronized drug. The process variables studied were inlet air temperature, inlet air flow, spray rate of the binder solution, and atomization air pressure. Tablets with identical composition, weight, size and hardness were also manufactured in a high shear granulator and their physical properties were determined and compared with those produced by the fluidized bed granulation method. Except for the granule size distribution, other physical properties of granulations and tablets produced in a fluid bed granulator are independent of the selected process variables within the study range. Both atomization air pressure and spray rate of the binder solution had strong impact on granule size distribution. Irrespective of the process conditions used in the fluid bed granulation, granules from this process were more porous, less dense and more compressible than the granules from the high shear granulation process. Comparable tablet dissolution rates to those prepared by the optimized high shear granulation method can be achieved by selecting the appropriate process conditions in fluid bed granulation. These results suggest that wet granulation tablets of a high dose, poorly water soluble, low density, micronized drug can be manufactured using a fluidized bed granulation method, with comparable tablet dissolution rates to those produced with an optimized high shear granulation method.