Measuring elastic properties of bones and silicon from V(z) curve generated by multiply reflected signals

Acoustic microscopes can be used to measure Rayleigh and longitudinal or P-wave speeds in a specimen at microscopic resolution. The wave speeds are obtained from the interference pattern as a function of the defocus distance or V(z) curve. The received signal voltage amplitude Vis generated by two beams--the normally reflected central beam and a non-specularly reflected beam that strikes the fluid-solid interface at critical angle. It is shown in this paper that instead of analyzing the interference pattern between these two beams if we consider two other beams that follow the same path but travel through the coupling fluid multiple times before interfering then the V(z) curve generated by this higher order interference gives more accurate values for the material properties. The spacing distance between two successive dips of the V(z) curve is smaller for the higher order interference. The higher order interference, although weaker, gives more accurate results. Justification for the greater accuracy of the higher order interference is given in the paper. Material properties of silicon and bone are obtained by the new technique. Bones are microscopically heterogeneous and anisotropic. Anisotropic properties of homogeneous specimens can be obtained by the line focus acoustic microscope; however, it does not work when the specimen is microscopically heterogeneous. An attempt has been made here to obtain anisotropic properties of bones using point focus lens.