The hydraulic conductivity of the rat proximal tubular wall determined with colloidal solutions

The hydraulic conductivity of the rat proximal tubular wall was determined using colloidal solutions perfused in short (50--200 mum) (SMP) or long (90--200 mum) (LMP) proximal tubular segments. In SMP human serum albumin (HSA) or polyvinylpyrrolidone (PVP) was added to raffinose solutions. A Lp of 0.019 nl-min-1-mm-1-mm Hg-1 was found when high colloid concentrations were used while values of 0.055--0.092 were found when low colloid concentrations were used. In other experiments, the Lp was determined by perfusing short tubular segments with pure raffinose solutions. A value of 0.015 nl-min-1-mm-1-mm Hg-1 was found. This is twice the value found when raffinose solutions were perfused through long tubular segments and it is concluded that the short microperfusion technique overestimates Lp with a factor of two. When microperfusions of long tubular segments were conducted, PVP was added to an equilibrium solution consisting of NaCl (110 mM) and raffinose (80 mM). Lp was found to be 0.018--0.021 when high colloid concentrations were used, while a value of 0.029 was found when a low colloid concentration was used. As found in both SMP and LMP a decrease in Lp's with increasing colloid concentrations indicates that a significant influence of radial concentration differences is highly probable. It is therefore suggested that the highest Lp derived when using the lowest colloid concentrations represents the best estimate. With this Lp value (0.03--0.05 nl-min-1-mm-1-mm Hg-1) and the existing transtubular hydrostatic and oncotic pressure difference it can be calculated that these passive forces might constitute the driving force for 1/3 of the fluid reabsorbed in the proximal tubule.