Cell adhesion and morphology in porous scaffold based on enantiomeric poly(lactic acid) graft-type phospholipid...

Poly(D-lactic acid) (PDLA) and poly(L-lactic acid) (PLLA) macromonomers were synthesized for preparation of a novel cytocompatible polymer. The cytocompatible polymer was composed of 2-methacryloyloxyethyl phosphorylcholine (MPC), n-butyl methacrylate (BMA), and the enantiomeric PLLA (or PDLA) macromonomer. The degree of polymerization of the lactic acid in the PLLA and PDLA segments was designed to be ca. 20. The copolymer-coated surface was analyzed with static contact angle by water. From the result, the PLLA (or PDLA) segment and MPC unit were located on the coated surface, and the monomer unit in the copolymer was reconstructed by contacting water. Fibroblast cell culture was performed to evaluate cell adhesion on the coated surface, and the cell morphology was observed. The number of cell adhesion is correlated with the PL(D)LA content, and the cell morphology is correlated with the MPC unit content. The porous scaffold was prepared by the formation of a stereocomplex between the PLLA and PDLA, and the cell adhesion and following cell intrusion was then evaluated. The fibroblast cells adhered on the surface and intruded into the scaffold through the connecting pores after 24 h. The cell morphology became round shape from spreading with the decreasing PLLA (or PDLA) content in the copolymer. It is considered that the change in the cell morphology would be induced by the MPC unit as cytocompatible unit. These findings suggest that the porous scaffold makes it possible to have cytocompatibility and to produce three-dimensional tissue regeneration.