Adaptation of a manometric biosensor to measure glucose and lactose

A manometric sensor previously developed to measure urea was modified to measure glucose and lactose through enzymatic oxidation. Change in pressure in an enclosed cavity was correlated to the depletion of oxygen resulting from the enzymatic oxidation of glucose or lactose. The response of the sensor was linear and could be made adjustable over a large range by adjusting the amount of sample loaded into the fixed volume reactor. Because of the slow mutarotation of glucose, the oxidation of glucose was not allowed to proceed to completion. Therefore, the precision of the sensor (approximately 0.2 mM in a range from 0 to 5 mM) was limited by variations in the oxidation rate of glucose by glucose oxidase. Because the assay for lactose measured glucose subsequent to the hydrolysis of lactose by beta-galactosidase, the same degree of precision was observed in lactose. Milk lactose, typically at concentrations of about 150 mM, was estimated using the lactose assay after first diluting the samples. For many fluids such as milk, the use of manometric sensors for oxidizable substrates may be preferable to optical and electrochemical methods because they are robust and suffer a low degree of optical and chemical interferences. Glucose and lactose are representative of many important oxidizable substrates, which may be determined in this manner, many of which do not suffer from limitations caused by mutarotation. In theory, detection limits less than 1 microM may be achieved using these methods.