Related Experiment Video
Updated: Sep 27, 2026

Original Experimental Approach for Assessing Transport Fuel Stability
Published on: October 21, 2016
Preliminary characterization of anhydrous ethanol used in Brazil as automotive fuel
Rossana B C Vilar1, Rosângela da Silva, Patricia Schossler
1Instituto de Química da Universidade Federal do Rio Grande do Sul, Av, Bento Gonçalves 9550, Porto Algre 90501-970, Brazil.
Abstract:
This work reports preliminary studies on the characterisation of anhydrous ethanol (AEA) used as an automotive fuel mixed with gasoline in Porto Alegre (South Brazil). Pre-concentration of the impurities contained in 1000 ml of AEA was carried on through solid-phase extraction using XAD4 resin. The main compounds in the extract were identified by means of spectral data from the library of the equipment. The concentrate was then fractionated using a preparative liquid chromatographic column filled with activated silica gel and the elution procedure was carried out with, n-hexane, n-hexane-benzene (1:1, v/v) and dichloromethane. Prior to analysis by GC-MS, each fraction was reduced to 1 ml with a gentle stream of nitrogen. Saturated linear hydrocarbons and aromatic hydrocarbons eluted in the first fraction and oxygenated compounds such as aldehydes. ketones and alcohols, eluted in the second one. were the main compounds detected in the sample.
Related Concept Videos
Production of Alcohol
Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis
Ethers can be prepared from organic compounds by various methods. Some of them are discussed below,
Preparation of Ethers by Alcohol Dehydration
In this method, in the presence of protic acids, alcohol dehydrates to produce alkenes and ethers under different conditions. For example, in the presence of sulphuric acid, dehydration of ethanol at 413 K yields ethoxyethane, whereas it yields ethene at 443 K.
Physical Properties of Ethers
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
Ethers from Alkenes: Alcohol Addition and Alkoxymercuration-Demercuration
Ethers can also be prepared from alkenes through acid-catalyzed addition of alcohols and alkoxymercuration–demercuration.
Preparation of Ethers by Acid-Catalyzed Addition of Alcohol to Alkenes
The acid-catalyzed addition of alcohol to an alkene involves treating the alkene with an excess of alcohol in the presence of an acid catalyst to form an ether under suitable conditions. The hydrogen will add to the less substituted carbon so that the nucleophile can attack the more substituted...
Preparation of Alcohols via Addition Reactions
The acid-catalyzed addition of water to the double bond of alkenes is a large-scale industrial method used to synthesize low-molecular-weight alcohols. An acidic atmosphere is required to allow the hydrogen in the water molecule to act as an electrophile and attack the double bond in an alkene. The addition of a proton to the double bond creates a carbocation intermediate. The proton preferentially bonds to the less substituted end of the double bond to create a more stable carbocation...
Preparation of Alcohols via Substitution Reactions
Alcohols can be synthesized from alkyl halides via nucleophilic substitution reactions. The highly polar carbon-halogen bond in the substrate makes halide a good leaving group. The hydroxide ion or water can act as a nucleophile to take the place of halide and form an alcohol. The substitution reactions occur via two different reaction pathways, SN1 or SN2, depending on the nature of carbon attached to the halide.
Primary alcohols are synthesized from primary alkyl halides, and the...

