Size-effect on the physical characteristics of the aerobic granule in a SBR

Owing to a fast growth rate, aerobic granules display a wide range of sizes, approximately 0.3-5.0 mm in diameter. As the diameter increases, the aerobic granule undergoes serial morphological and physical changes that could cause problems to the reactor operation, a phenomenon which, however, has not been fully studied hitherto. In this study, aerobic granules from a sequencing batch reactor were mechanically separated into various size-categories in order to investigate their physical properties, including sludge volumetric index (SVI), settling velocity (sv), specific surface hydrophobicity, granule strength, total solids, percentage volatile solids and other structural properties. Also, the live and dead biomass distribution was examined under a confocal laser scanning microscope after treatment with nucleic acid viability stains. Regardless of size, the biomass (both live and dead) was densest in the outer layer of the granule, which was about 600+/-50 microm thick. The live cells appeared only in the peripheral zone, while dead biomass spread into the inner zone. The biomass distribution pattern justified the changing physical properties of the granules as they grew bigger. As size increased, the sv, granule total density and biomass density increased but not in parallel with the size increment, while the granule strength, specific surface hydrophobicity and SVI decreased. Nonetheless, beyond a threshold size (4.0 mm diameter), the granules presented peculiar values in those properties, deviating from the initial trends. This was due to both inner and outer structural changes. The physical properties associated significantly with the size factor, for which the correlation coefficients were above 0.67. In view of biological viability and physical properties, the operational size-range suggested for optimal performance and economically effective aerobic SBR granular sludge is a diameter of 1.0-3.0 mm.