Related Experiment Video
Updated: Jul 28, 2026
Non-fluoroscopic Catheter Tracking for Fluoroscopy Reduction in Interventional Electrophysiology
Published on: May 26, 2015
Optimization of ECG gating in quantitative femoral angiography
S Nilsson1, I Berglund, U Erikson
1Department of Oncology, Radiology and Clinical Immunology, University Hospital, SE-751 85 Uppsala, Sweden. sven.nilsson@radiol.uu.se
Purpose:
To determine which phase of the heart cycle would yield the highest reproducibility in measuring atherosclerosis-related variables such as arterial lumen volume and edge roughness.
Material And Methods:
35 patients with hypercholesterolemia underwent select- ive femoral angiography, repeated four times at 10-min intervals. The angiographies were performed with ECG-gated exposures. In angiographies 1 and 2 the delay from R-wave maximum to each exposure was 0.1 s, in angiographies 3 and 4 the delay was 0.1, 0.3, 0.5 or 0.7 s or the exposures were performed 1/s without ECG gating. Arterial lumen volume and edge roughness were measured in a 20-cm segment of the superficial femoral artery using a computer-based densitometric method. Measurement reproducibility was determined by comparing angiographies 1-2 and angiographies 3-4.
Results:
When measuring arterial lumen volume and edge roughness of a 20-cm segment of the femoral artery, reproducibility was not dependent on ECG gating. In measuring single arterial diameters and cross-sectional areas, the reproducibility was better when exposures were made 0.1 s after the R-wave maximum than when using other settings of the ECG gating device or without ECG gating.
Conclusion:
The influence of pulsatile flow upon quantitative measurement in femoral angiograms seems to be the smallest possible in early systole, as can be demonstrated when measuring single diameters and cross-sectional areas. In variables based on integration over longer segments, measurement reproducibility seems to be independent of phase.
