Related Experiment Video
Updated: Aug 30, 2026

Sound Source Localization Testing in Single-sided Deafness Following Bone Conduction Intervention
Published on: December 20, 2024
Time course of loudness recalibration: implications for loudness enhancement
1John B. Pierce Laboratory and Yale University, New Haven, Connecticut 06519, USA. yarieh@jbpierce.org
Abstract:
Loudness recalibration, the effect of a relatively loud 2500-Hz recalibrating tone on the loudness of a relatively soft 2500-Hz target tone, was measured as a function of the interstimulus interval (ISI) between them. The loudness of the target tone, assessed by a 500-Hz comparison tone, declined when the ISI equaled or exceeded about 200 ms and leveled off at an ISI of about 700 ms. Notably, the target tone's loudness did not change significantly at very short ISIs (< 150 ms). The latter result is incompatible with the literature reporting loudness enhancement in this time window, but is compatible with the suggestion made by Scharf, Buus, and Nieder [J. Acoust. Soc. Am. 112, 807-810 (2002)] that early measurements of enhancement were contaminated by the influence of the recalibrating tone on the comparison tone when the two shared the same frequency. In a second experiment the frequency of the comparison tone was changed to 2500 Hz and the results of a loudness enhancement paradigm was successfully predicted from the time course of recalibration obtained in experiment 1.
Related Concept Videos
Applications of Logarithms
Sound Intensity Level
The human ear can perceive an extensive range of sound intensity, necessitating the use of the logarithmic scale to define a physical quantity—the intensity level. It is a ratio of two intensities and hence a...
Perceiving Loudness, Pitch, and Location
Place theory, or place coding, suggests that different pitches are heard because various sound waves activate specific locations along the cochlea's basilar membrane. The brain determines the pitch of a sound by identifying...
Design Example: Vintage Mixing Console
The specifications for the pre-amplifier were clear. It needed to amplify the audio signal by a factor of 10, have an input impedance above 10...

