Co-removal of hexavalent chromium through copper precipitation in synthetic wastewater

The mechanisms of hexavalent chromium [Cr(VI)] co-removal with copper [Cu(II)] during homogeneous precipitation were studied with batch tests using a synthetic solution containing Cr(VI) and Cu(II). Metal precipitation was induced by adding Na2CO3 stepwise to different pH, and the respective removals of Cu(II) and Cr(VI) were measured. At the same time, the relative quantities of Cu(II) and Cr(VI) in the precipitates were also analyzed to establish their stoichiometric relationship. The results indicated that, in a solution containing 150 mg/L Cu(II) and 60 mg/L Cr(VI), the initial co-removal of Cr(VII with Cu(II) began at pH 5.0 and completed at pH 6.2. At pH 5.0-5.2, coprecipitation took place through the formation of copper-chromium-bearing solids [such as CuCrO4 and/or CuCrO4 x 2Cu(OH)2]. Thereafter, the remaining soluble copper started to react with carbonate in a heterogeneous environment to form the negatively charged basic copper carbonate precipitates [CuCO3 x Cu(OH)2], which subsequently adsorbed additional Cr(VI) (or HCrO4-) at pH 5.2-6.2. The maximum Cr(VI) co-removal took place at pH 6.2. Between the two mechanisms, co-precipitation accounted for about 29% of the total chromium's co-removal while the remaining 71% was attributed to surface adsorption, mainly through electrostatic attraction and ligand exchange. When the solution pH was increased to beyond 7.5, a surface charge reversal took place on the basic copper carbonate solids, and this led to some Cr(VI) desorption. Thus, the extent of Cr(VI) adsorption is highly pH dependent.