Related Experiment Video
Updated: Aug 29, 2026

Basic Methods for the Study of Reproductive Ecology of Fish in Aquaria
Published on: July 20, 2017
Kin-biased distribution in brown trout: an effect of redd location or kin recognition?
J Carlsson1, J E L Carlsson, K H Olsén
1Danish Institute for Fisheries Research, Department of Inland Fisheries, Vejlsøvej 39, DK-8600 Silkeborg, Denmark. jc@vims.edu
Abstract:
A wide range of animals have been reported to show kin-biased behaviours, such as reduced aggressiveness and increased food sharing among relatives. However, less is known about whether wild animals also associate with relatives under natural conditions, which is a prerequisite to facilitate kin-biased behaviours and hence kin selection. We tested, by means of microsatellite polymorphism, correlations between pair-wise relatedness and pair-wise metric distance in wild brown trout (Salmo trutta L.) under natural conditions in two streams. Our data show that young-of-the-year as well as older trout found close together also had a higher genetic relatedness in one of the two streams, whereas no relationship was found in the other stream. Very few half and full siblings were found in the second stream and under these conditions it is unlikely that kin-biased behaviours will receive positive selection. We discuss the underlying mechanisms for the observed structure and we specifically address the issue of whether the grouping of related individuals could reflect dispersal from the same spawning redds, or if it reflects active association with relatives, possibly conferring kin-selected advantages.
Related Concept Videos
Fixed Action Patterns
Testing a Claim about Population Proportion
There are two methods of testing a claim about a population proportion: (1) Using the sample proportion from the data where a binomial distribution is approximated to the normal distribution and (2) Using the binomial probabilities calculated from the data.
The first method uses normal distribution as an approximation to the binomial distribution. The requirements are as follows: sample size is large...
Rate of Change: Problem Solving
Testing a Claim about Mean: Known Population SD
Estimating a population mean requires the samples to be distributed normally. The data should be collected from the randomly selected samples having no sampling bias. The sample size needed to be higher than 30, and most importantly, the population standard deviation should be already known.
In most realistic situations, the population standard deviation is often unknown, but in rare circumstances, when it...
Inclusive Fitness
Position-effect Variegation

