Related Experiment Video
Updated: Aug 17, 2026

A Generalized Method for Determining Free Soluble Phenolic Acid Composition and Antioxidant Capacity of Cereals and Legumes
Published on: June 10, 2022
Characterization of physicochemical properties of ferulic acid
1College of Pharmacy, Duksung Womens University, 132-714 Seoul, Korea. ytsohn@duksung.ac.kr
Abstract:
Ferulic acid (3-methoxy, 4-hydroxy cinnamic acid) is a flavoid component possessing antioxidant property. The compound is currently under development as a new drug candidate for the treatment of the dementia. The objective of this preformulation study was to determine the physicochemical properties of ferulic acid. The n-octanol to water partition coefficients of ferulic acid were 0.375 and 0.489 at the pHs of 3 and 10, respectively. Accelerated stability study for ferulic acid indicated that the t 90 value for the drug was estimated to be 459 days at 25 degrees C. Ferulic acid was also found to be unstable under the relative humidity of more than 76%, probably because of the hygroscopic nature of the drug. In order to study compatibility of ferulic acid with typical excipients, potential change in differential scanning calorimetry spectrum was studied in 1:1 binary mixtures of ferulic acid and typical pharmaceutical excipients (e.g., Aerosil, Avicel, CMC, Eudragit, lactose, PEG, PVP, starch and talc). Avicel, CMC, PVP and starch were found to be incompatible with ferulic acid, indicating the addition of these excipients may complicate the manufacturing of the formulation for the drug. Particle size distribution of ferulic acid powder was in the size range of 10-190 microm with the mean particle size of 61 microm. The flowability of ferulic acid was apparently inadequate, indicating the granulation may be necessary for the processing of the drug to solid dosage forms. Two polymorphic forms were obtained by recrystallization from various solvents used in formulation. New polymorphic form of ferulic acid, Form II, was obtained by recrystallization from 1,4-dioxane. The equilibrium solubility for Form I was approximately twice of that for Form II. The dissolution rate of Form II was higher than that of Form I in the early phase (<6 min). Therefore, these physicochemical information has to be taken in the consideration for the formulation of ferulic acid.
Related Concept Videos
Physical Properties Affecting Solubility
As for any solution, the solubility of a gas in a liquid is affected by the attractive intermolecular forces between solute and solvent species. Unlike solid and liquid solutes, however, there is no solute-solute intermolecular attraction to overcome when a gaseous solute dissolves in a liquid solvent since the atoms or molecules comprising a gas are far separated and experience negligible interactions. Consequently, solute-solvent interactions are the sole...
Physical Properties of Alcohols and Phenols
Alcohols possess a higher boiling point than aliphatic hydrocarbons of similar...
IR and UV–Vis Spectroscopy of Carboxylic Acids
However, the stretching absorptions for the C=O bond vary depending on the structure of carboxylic acids. The C=O bond of the free carboxylic acids shows a higher stretching frequency, 1760 cm−1, while H-bonded carboxylic acids (dimers) exhibit stretching absorptions at a lower frequency, 1710 cm−1. The C=O bond of the...
Physical Properties of Carboxylic Acid Derivatives
Among the carboxylic acid derivatives, the boiling points of acid chlorides and esters are very similar and are the lowest in the series. Acid anhydrides have slightly higher boiling...
UV–Vis Spectroscopy: Woodward–Fieser Rules
Physical Properties of Carboxylic Acids

