Mechanical properties of biodegradable ligament augmentation device of poly(L-lactide) in vitro and in vivo

To evaluate the mechanical properties of absorbable braided poly(L-lactide) (PLLA) fibre implants, 2.0 and 3.2 mm in diameter, maximum load defined as tensile load carrying capacity, elongation and axial rigidity were investigated after immersion in phosphate-buffered distilled water at 37 degrees C and pH 6.1 and after subcutaneous implantation in rabbit. The results confirm earlier indications that PLLA degrades faster in vivo than in vitro. The non-sterilized 2.0 mm implants lost 69% of initial tensile load carrying capacity in 46 wk in vitro. In vivo the loss of tensile load carrying capacity of the 2.0 and 3.2 mm implants was most marked between 6 to 12 wk. After 48 wk in vivo 2.0 and 3.2 mm implants retained 3 and 4% of initial tensile load carrying capacity respectively. Both in vitro and in vivo, elongation diminished in the same way as the maximum load. In vitro, mean axial rigidity of unsterilized 2.0 mm implants was 64 N during the first 34 wk but fell to 31 N at 46 wk. In vivo the initial mean axial rigidity of the 2.0 and 3.2 mm implants was 29 and 95 N respectively. At 24 wk the mean axial rigidity was 2 N in both implants.