Mechanism of rectification in inward-rectifier K+ channels

Zhe Lu1

  • 1Department of Physiology, University of Pennsylvania, Philadelphia, Pennsylvania 19104, USA. zhelu@mail.med.upenn.edu

Annual Review of Physiology
|February 24, 2004
PubMed

Related Concept Videos

RL Circuits01:14

RL Circuits

An RL circuit consists of a resistor and an inductor and may have a source of emf connected to it. The inductor in the circuit helps to prevent rapid changes in current, which can be helpful if a steady current is required but the external source has a fluctuating emf. Consider an open RL circuit connected to a source of constant emf. As soon as the circuit is closed, the current begins to increase at a rate that depends only on the value of the inductance in the circuit. The greater the...
Modeling of Diode Forward Characteristics01:19

Modeling of Diode Forward Characteristics

Understanding the behavior of diodes when forward-biased is a fundamental aspect of electronic circuit design and analysis. This analysis primarily utilizes two models: the exponential diode model and the constant-voltage-drop model. The exponential model comes into play when the source voltage exceeds 0.5 volts, pushing the diode current to rise exponentially above the saturation current. This relationship is graphically depicted in the current-voltage (I-V) curve, illustrating the diode's...
Half wave rectifier01:20

Half wave rectifier

A half-wave rectifier is a fundamental circuit in electronics, designed to convert alternating current (AC) voltage into a unidirectional voltage. It utilizes the simplest form of diode rectification, where the circuit comprises a single diode in series with a load resistor and an AC power source.
Full wave rectifier01:22

Full wave rectifier

A full-wave rectifier is a device that converts alternating current (AC) to direct current (DC) and is more efficient than its half-wave counterpart. It typically includes a center-tapped transformer, two diodes, and a load resistor. The secondary winding of the transformer is divided to provide two equal voltages of opposite polarities, which is the pivotal element of full-wave rectification.
Bridge rectifier01:24

Bridge rectifier

The bridge rectifier is essential in electronics for efficiently converting alternating current (AC) to direct current (DC). Comprised of four diodes configured in a bridge layout, this rectifier effectively processes both the positive and negative halves of the AC waveform, making it superior to half-wave and full-wave center-tapped rectifiers in terms of voltage regulation and output stability.
Operationally, the bridge rectifier allows current flow through two of its diodes during each...
Voltage Doubler Circuit01:23

Voltage Doubler Circuit

A voltage doubler circuit integrates two main components: a clamping section and a rectifier section. The clamping section consists of a capacitor (C1) and a diode (D1), whereas the rectifier section is equipped with another diode (D2) and capacitor (C2). This circuit produces an output voltage with twice the amplitude of the sinusoidal input voltage.