[A new method of identifying a systems based on the minimal quadratic discrepancy criterion for biophysics problems]

A V Karnaukhov1, E V Karnaukhova

  • 1Institute of Cell Biophysics, Russian Academy of Sciences, Pushchino, Moscow Region, 142290 Russia. akarn@icb.psn.ru

Biofizika
|March 20, 2004
PubMed

Related Concept Videos

Gaussian Elimination: Problem Solving01:30

Gaussian Elimination: Problem Solving

Systems of linear equations in several variables are pivotal in modeling complex scenarios involving multiple unknowns and constraints. Such systems are widely used in various fields to represent relationships where several conditions must be simultaneously satisfied. Each variable in the system corresponds to an unknown quantity, while each equation imposes a linear constraint, leading to a structured approach for analyzing and solving real-world problems.A system of three equations with three...
One-Compartment Open Model: Wagner-Nelson and Loo Riegelman Method for ka Estimation01:24

One-Compartment Open Model: Wagner-Nelson and Loo Riegelman Method for ka Estimation

This lesson introduces two critical methods in pharmacokinetics, the Wagner-Nelson and Loo-Riegelman methods, used for estimating the absorption rate constant (ka) for drugs administered via non-intravenous routes. The Wagner-Nelson method relates ka to the plasma concentration derived from the slope of a semilog percent unabsorbed time plot. However, it is limited to drugs with one-compartment kinetics and can be impacted by factors like gastrointestinal motility or enzymatic degradation.
On...
¹H NMR: Interpreting Distorted and Overlapping Signals01:02

¹H NMR: Interpreting Distorted and Overlapping Signals

Spin systems where the difference in chemical shifts of the coupled nuclei is greater than ten times J are called first-order spin systems. These nuclei are weakly coupled, and their chemical shifts and coupling constant can generally be estimated from the well-separated signals in the spectrum.
As Δν decreases and the signals move closer, the doublets appear increasingly distorted. The intensities of the inner lines increase at the cost of those of the outer lines as the signals are slanted or...
The Small x Assumption02:20

The Small x Assumption

If a reaction has a small equilibrium constant, the equilibrium position favors the reactants. In such reactions, a negligible change in concentration may occur if the initial concentrations of reactants are high and the Kc value is small. In such circumstances, the equilibrium concentration is approximately equal to its initial concentration. This estimation can be used to simplify the equilibrium calculations by assuming that some equilibrium concentrations are equal to the initial...
Quadratic Equations in the Complex Number System01:29

Quadratic Equations in the Complex Number System

A quadratic equation in the form ax2+bx+c=0 can have solutions that vary in nature depending on the value of the discriminant, b2−4ac. In this expression, a is the coefficient of the quadratic term x2, b is the coefficient of the linear term x, and c is the constant term. When the discriminant is negative, the equation has no real number solutions. However, by introducing complex numbers through the imaginary unit i, defined by i=-1, these equations can still be solved.The square root of a...
Constraints and Statical Determinacy01:26

Constraints and Statical Determinacy

In structural engineering, the equilibrium of a system is not only determined by its equations of equilibrium but also with the help of constraints. Constraints refer to restrictions on the motion of a system. The proper combinations of constraints can minimize the total number of constraints needed to maintain a system in mechanical equilibrium. When this happens, the system is said to be statically determinate. For such systems, the unknown reaction supports can be estimated using equilibrium...