Related Experiment Video
Updated: Aug 24, 2026
Simultaneous Multi-surface Anodizations and Stair-like Reverse Biases Detachment of Anodic Aluminum Oxides in Sulfuric and Oxalic Acid Electrolyte
Published on: October 5, 2017
Alteration of the surface charge of aluminum goethites by a sulfonic acid buffer
1Department of Earth and Planetary Science, Center for Integrative Planetary Science, and NASA Astrobiology Institute, University of California at Berkeley, Hilgard Hall 3110, Berkeley, CA 94720-3110, USA. javiera@eps.berkeley.edu
Abstract:
Four samples of synthetic low-substitution Al-goethites (mol% Al<10) were incubated with 10 mM NaClO4 and 5 mM MES buffer (MES buffer (2-[N-morpholino]ethanesulfonic acid) at pH 5. It was found that MES buffer, although commonly used to control pH, profoundly affected the results of our electrophoretic mobility measurements. The presence of MES buffer caused a large decrease in EM values for unsubstituted goethite, from 5.7 +/- 0.7 to 1.8 +/- 0.4 m2 v(-1) s(-1), while increases in Al substitution in goethite led to a progressive increase in EM values. The charge reversal following addition of MES buffer to suspension containing Al-goethites was explained by specific sorption that, at pH 5, is thought to occur via cation surface complexation because of (i) sulfonate induced-dipole or (ii) N and O lone-pair dipole-dipole interactions with structural Fe.
Related Concept Videos
02:56Buffers
04:08Determining the pH of Salt Solutions
02:54Ions as Acids and Bases
Salts are ionic compounds composed of cations and anions, either of which may be capable of undergoing an acid or base ionization reaction with water. Aqueous salt solutions, therefore, may be acidic, basic, or neutral, depending on the relative acid-base strengths of the salt’s constituent ions. For example, dissolving the ammonium chloride in water results in its dissociation, as described by the equation:
02:45Calculating pH Changes in a Buffer Solution
01:19Acid Halides to Alcohols: LiAlH4 Reduction
The mechanism proceeds in three steps. First, the nucleophilic hydride ion attacks the carbonyl carbon of the acid halide to form a tetrahedral intermediate. Next, the carbonyl group is re-formed, and the halide ion departs as a leaving group, generating an aldehyde. A second nucleophilic attack by the hydride yields an alkoxide ion, which, upon protonation, gives a primary alcohol as...
01:29Sulfate Attack on Concrete
Sulfates from sources like soil, groundwater, or industrial effluents...