Related Experiment Video
Updated: Aug 24, 2026

Determining the Chemical Composition of Corrosion Inhibitor/Metal Interfaces with XPS: Minimizing Post Immersion Oxidation
Published on: March 15, 2017
Determination of parameters relevant to alpha spectrometry when employing source coating
N Vainblat1, O Pelled, U German
1NRC-Negev, P.O. Box 9001, Beer-Sheva 84190, Israel.
Abstract:
The recoil fragments from an alpha-emitting source may cause significant detector contamination. The simplest method to avoid the problem is to use a source coating. The influence of Mylar film coatings of different thickness on the resolution, efficiency and minimum detection level of an alpha spectrometry system was investigated. No significant deterioration of the system characteristics was observed when using thin films of about 0.25 mg/cm2.
More Related Videos
Related Concept Videos
Atomic Emission Spectroscopy: Lab
Atomic Absorption Spectroscopy: Radiation and Light Sources
Two common narrow-range 'line' sources used in AAS are hollow-cathode lamps (HCLs) and...
Atomic Absorption Spectroscopy: Lab
Solutions containing organic solvents, such as low-molecular-mass alcohols, esters, or ketones, enhance absorbances by increasing nebulizer...
Atomic Emission Spectroscopy: Overview
Atomic Emission Spectroscopy: Instrumentation
Atomic Absorption Spectroscopy: Interference
Spectral interference occurs when signals from other elements or molecules overlap with the analyte signal, falsely elevating or masking the analyte's absorbance. This interference can be corrected using Zeeman,...

