Related Experiment Video
Updated: Aug 23, 2026

A Freeze-Thawing Method to Prepare Chitosan-Poly(vinyl alcohol) Hydrogels Without Crosslinking Agents and Diflunisal Release Studies
Published on: January 14, 2020
A mathematical model of volatile release in mouth from the dispersion of gelled emulsion particles
Guoping Lian1, Mark E Malone, Jenny E Homan
1Unilever R&D Colworth, Sharnbrook, Bedfordshire MK44 1LQ, UK. Guoping.Lian@unilever.com
Abstract:
This paper presents a mathematical model of in-mouth volatile release from gelled emulsion particles dispersed in a continuous aqueous phase. Data based on APCI MS-Breath analysis is presented to demonstrate the effect of particle size, oil content and oil-water partition coefficients. It is shown that in-mouth release of aroma from the dispersion of gelled emulsion particles follows a two-component kinetic equation with fast and slow components. Both the fast and slow rate constants depend on the particle size, oil content and oil water partition coefficient of the aroma. The relative amount of aroma contributing to the fast and slow components also depends on the size of the particles. In order to understand this unexpected behaviour, an analytical model was developed that considers the interplay between the mass transfer of flavour across the interface of the particles and that across the air-liquid interface. Analytical expressions for the two rate constants and the relative ratio of aroma contributing to the fast component have been derived. From this model, three regimes of in-mouth release of aroma from the dispersion of gelled emulsion particles were identified including, the emulsion regime, the transition regime and the gel particle regime. In the emulsion regime, changes in the size of gelled emulsion particles had negligible impact on the overall release. In the transition regime, the release was controlled by the interaction of flavour transfer from the particles with that across the air-water interface. In the gel particle regime, aroma release at long times was governed by the particles and that at short times was governed by the air-water interface, and the two processes were fully decoupled. A simple relationship was derived for the critical size above which the release of aroma from the dispersion of gelled emulsion particles is affected by the size of the particles.
More Related Videos
10:20In vitro Digestion of Emulsions in a Single Droplet via Multi Subphase Exchange of Simulated Gastrointestinal Fluids
Published on: November 18, 2022
07:47Experimental Protocol to Investigate Particle Aerosolization of a Product Under Abrasion and Under Environmental Weathering
Published on: September 16, 2016
Related Concept Videos
Theories of Dissolution: The Danckwerts' Model and Interfacial Barrier Model
Theories of Dissolution: Diffusion Layer Model
This process starts with a thin layer, saturated with the drug, forming at the interface between the solid and liquid. The solute then diffuses from this layer into the main solution. The Noyes-Whitney equation suggests that the rate of dissolution relies on the diffusion...
Fluid Mosaic Model
The Kinetic Model of Gases
Two-Compartment Open Model: Extravascular Administration
The absorption exponent (ka) indicates the speed at which the drug is...
Distribution of Molecular Speeds