Characterization of hydrated Na+(phenol) and K+(phenol) complexes using infrared spectroscopy

Timothy D Vaden1, James M Lisy

  • 1Department of Chemistry, University of Illinois at Urbana-Champaign, Urbana, Illinois 61801, USA.

Related Concept Videos

Physical Properties of Alcohols and Phenols02:32

Physical Properties of Alcohols and Phenols

Alcohols are organic compounds in which a hydroxy group is attached to a saturated carbon. Phenols are a class of alcohols containing a hydroxy group attached to an aromatic ring. The physical properties of the alcohols and phenols are influenced by hydrogen bonding due to the oxygen–hydrogen dipole in the hydroxy functional group and dispersion forces between alkyl or aryl regions of alcohol and phenol molecules.
Alcohols possess a higher boiling point than aliphatic hydrocarbons of similar...
Acidity and Basicity of Alcohols and Phenols02:36

Acidity and Basicity of Alcohols and Phenols

Like water, alcohols are weak acids and bases. This is attributed to the polarization of the O–H bond making the hydrogen partially positive. Moreover, the electron pairs on the oxygen atom of alcohol make it both basic and nucleophilic. Protonation of an alcohol converts hydroxide, a poor leaving group, into water—a good one. The two acid–base equilibria corresponding to ethanol are depicted below.
IR Spectrum Peak Broadening: Hydrogen Bonding01:23

IR Spectrum Peak Broadening: Hydrogen Bonding

The vibrational frequency of a bond is directly proportional to its bond strength. As a result, stronger bonds vibrate at higher frequencies, while weaker bonds vibrate at lower frequencies. The stretching vibration of the strong O–H bond in alcohols and phenols (very dilute solution or gas phase) appears as a sharp peak at 3600–3650 cm−1.
However, the extent of hydrogen bonding influences the observed stretching frequency and band broadening. Intermolecular or intramolecular hydrogen bonding...
IR and UV–Vis Spectroscopy of Aldehydes and Ketones01:29

IR and UV–Vis Spectroscopy of Aldehydes and Ketones

Infrared spectroscopy, also known as vibrational spectroscopy, is mainly used to determine the types of bonds and functional groups in molecules. In aldehydes and ketones, the carbonyl (C=O) bond shows an absorption around 1710 cm-1. The C=O bond vibration of an aldehyde occurs at lower frequencies than that of a ketone. In addition to the C=O absorption in an aldehyde, the aldehydic C–H bond also gives two peaks in the 2700–2800 cm-1 range. This absorption, coupled with the C=O stretching, is...
NMR Spectroscopy and Mass Spectrometry of Aldehydes and Ketones01:15

NMR Spectroscopy and Mass Spectrometry of Aldehydes and Ketones

In aldehydes, the hydrogen atom connected to the carbonyl carbon helps distinguish aldehydes from other carbonyl compounds using ¹H NMR spectroscopy. The closeness of aldehydic hydrogen to the electrophilic carbonyl carbon highly deshields the hydrogen atom causing its signal to appear around 10 ppm in the ¹H NMR spectra. α hydrogens split the aldehydic proton signal, which helps identify the number of α hydrogens in the molecule. For instance, one α hydrogen creates a doublet for an aldehydic...
IR Frequency Region: Fingerprint Region01:03

IR Frequency Region: Fingerprint Region

IR spectra are divided into two main regions: the diagnostic region and the fingerprint region. The diagnostic region of the spectrum lies above 1500 cm−1. The absorptions resulting from single-bond vibrations of the N–H, C–H, and O–H stretch at higher wavenumbers and appear on the left side of the spectrum. The stretching absorptions of the C≡C and C≡N occur between 2100–2300 cm−1. In contrast, those arising from stretching absorptions of the C=O, C=N, and C=C occur between 1600–1850 cm−1.
The...