Repeatability of Phase 1 habitat survey

As the major part of a Habitat Survey of Wales, over 80% of the land surface was surveyed in the field between 1987 and 1997 using the Phase 1 method. A resurvey of 294 randomly selected points was carried out during the early stages to audit the quality of the data being collected, leading to the development of a set of recommendations for the surveyors to improve the consistency and accuracy of habitat mapping. Recent studies have indicated a high level of discrepancy between organisations in field habitat mapping using the Phase 1 method. The findings of the Phase 1 audit in Wales are presented here to show the level of repeatability that was achieved within an organisation. There was 76% correspondence in habitat mapping between 'surveyor' and 'assessor' at the level of individual Phase 1 habitat classes. The degree of repeatability varied according to habitat strata: it was highest for modified land cover types (88%), lowest for semi-improved types (56%) and intermediate for semi-natural types (75%). An overall estimate of the repeatability of Phase 1 survey in the study area of 83% was obtained by weighting the figures for the three strata by the proportion of land area occupied by each stratum. This figure increased to 85% when habitats were amalgamated into Broad Habitat groups. These results are considerably better than those reported by studies of consistency between organisations. Most of the discrepancies between surveyor and assessor were caused by differences in habitat identification. However, at almost two thirds of the points where such a difference occurred, the assessor noted that the vegetation was transitional or borderline with that mapped by the surveyor.