Related Experiment Video
Updated: Aug 21, 2026

Prospecting Microbial Strains for Bioremediation and Probiotics Development for Metaorganism Research and Preservation
Published on: October 31, 2019
Using solar and ultraviolet light to degrade PCBs in sand and transformer oils
M A Manzano1, J A Perales, D Sales
1Department of Chemical Engineering and Environmental Technology, Faculty of Marine and Environmental Sciences, Cádiz University, Polígono Río San Pedro s/n, 11510 Puerto Real, Cádiz, Spain. manuel.manzano@uca.es
Abstract:
The present study describes the effect of the operating variables in the sensitized solar photolysis of sandy sediments contaminated by polychlorinated biphenyls (PCBs) in alkaline isopropanol. PCBs were almost completely removed in two weeks with stoichiometric release of chloride and biphenyl (BP) by a mechanism of reductive dechlorination. The concentration of the sensitizer (acetone) was the variable found to have most influence on the process. Under the same conditions, only partial dechlorination of the PCBs (34%) was observed in dielectric fluids without generating biphenyl to any appreciable extent. Direct photolysis (ultraviolet light at 254nm) of dielectric oils dissolved in alkaline isopropanol lead to 92% removal of PCBs in 60min. The observed mechanism was again that of reductive dechlorination, with stoichiometric release of chloride, and the accumulation of biphenyl, quaterphenyl and condensation products of biphenyl with isopropanol.
Related Concept Videos
Microbial Bioremediation of Hydrocarbons
Bioremediation
Microbial Bioremediation of Plastics
Microbial Bioremediation of Pesticides
Biological Treatment of Effluent and Waste Water
Bioplastics

