A novel dual-diameter ureteroscope working channel: impact on irrigant flow

To compare irrigant flow characteristics through standard working channels (3.6F to 4.5F) and a dual-diameter working channel. Irrigant flow is critical for adequate visualization during endoscopic procedures.

Working channels were created out of 80 cm of light wall polytetrafluoroethylene (PTFE) tubing (inner diameter 3.6F, 4.0F, and 4.5F) with a male Luer connector attached to one end by epoxy resin. The dual-diameter working channel was created with a 70-cm segment of PTFE (4.5F inner diameter, 0.059 in.) and a 10-cm segment of PTFE (3.6F inner diameter, 0.047 in.) with a male Luer connector attached to the free end of the 4.5F tubing. Stone basket shafts (100 cm in length, outer diameter 1.9F, 2.4F, and 3.0F) were created out of unmodified polyimide tubing with a 0.018-in.-diameter nitinol mandrel epoxy core for stability. Irrigant flow was measured at 100 mm Hg pressure for 1 minute with an empty channel and with stone basket shafts in the channel.

The flow rates were significantly greater with the dual-diameter working channel than with the standard flexible ureteroscope (3.6F) working channel using an empty channel (79.2 versus 44.1 mL/min, P = 0.0001), 1.9F basket (35.9 versus 10.0 mL/min, P = 0.003), 2.4F basket (20.7 versus 4.3 mL/min, P = 0.002), and 3.0F basket (6.0 versus 0.7 mL/min, P = 0.0002) sheath.

A dual-diameter working channel may optimize irrigant flow characteristics for flexible ureteroscopes while maintaining a small distal tip diameter.