Mechanical properties of cast Ti-Hf alloys

This study examined the mechanical properties of a series of Ti-Hf alloys. Titanium alloys with 10 to 40 mass % Hf were made with titanium and hafnium sponge in an argon-arc melting furnace. Specimens cast into magnesia-based investment molds were tested for yield strength, tensile strength, percentage elongation, and modulus of elasticity. Vickers microhardness was determined at 25 to 600 microm from the cast surface. X-ray diffractometry was also performed. Commercially pure Ti (CP Ti) and pure Ti prepared from titanium sponge were used as controls. The data (n = 5) were analyzed with a one-way ANOVA and the Student-Newman-Keuls test (alpha = 0.05). The diffraction peaks of all the metals matched those for alpha Ti; no beta phase peaks were found. Alloys with Hf > or = 25% had significantly (p < 0.05) higher yield and tensile strength compared to the CP Ti and pure Ti. There were no significant differences (p > 0.05) in elongation among all the Ti-Hf alloys and CP Ti, whereas the elongation of alloys with Hf > or = 30% was significantly (p < 0.05) lower than that of the pure Ti. The cast Ti-Hf alloys tested can be considered viable alternatives to CP Ti because they were stronger than CP Ti and had similar elongation.