Related Experiment Video

Updated: Aug 19, 2026

Fabrication, Operation and Flow Visualization in Surface-acoustic-wave-driven Acoustic-counterflow Microfluidics
12:26

Fabrication, Operation and Flow Visualization in Surface-acoustic-wave-driven Acoustic-counterflow Microfluidics

Published on: August 27, 2013

New architectures for feedthrough SAW recursive devices

Alexander N Kalashnikov1, Richard E Challis

  • 1School of Electrical and Electronic Engineering, The University of Nottingham, Nottingham, UK. alexander.kalashnikov@nottingham.ac.uk

IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
|March 4, 2005
PubMed

More Related Videos

Operation of the Collaborative Composite Manufacturing (CCM) System10:09

Operation of the Collaborative Composite Manufacturing (CCM) System

Published on: October 1, 2019

Advanced Workflow for Taking High-Quality Increment Cores - New Techniques and Devices07:40

Advanced Workflow for Taking High-Quality Increment Cores - New Techniques and Devices

Published on: March 10, 2023

Related Concept Videos

Brick Cutting Techniques01:08

Brick Cutting Techniques

Brick-cutting techniques involve various tools and methods to shape bricks for construction. A mason's hammer with a chisel-pointed end is used for basic shaping through sharp, precise strikes. For more complex shapes requiring higher precision, a power saw with a water-cooled diamond blade is used.
Cut bricks are categorized by size. Bricks cut to half their original length are called half-bats, while those cut to three-fourths their length are known as three-fourth bats.
Special types of cut...
Three-Winding Transformers01:19

Three-Winding Transformers

Three identical single-phase transformers can be configured to form a three-phase transformer connection, which involves high-voltage and low-voltage windings. The high-voltage windings are denoted by capital letters A-B-C, while the low-voltage windings are labeled with lowercase letters a-b-c, representing their respective phases. This notation helps distinguish between the high and low voltage sides of the transformer.
In the per-unit equivalent circuit of a grounded Y-Y three-phase...
Lumber01:19

Lumber

Lumber is derived from logs which are harvested, debarked, and processed into long pieces with a rectangular cross-section. The transformation of logs into lumber involves multiple steps, beginning with an automated saw that slices the log into slabs. These slabs are then transported via a conveyor belt to smaller saws, where they are cut into square-edged pieces of specific widths.
Initially, the surfaces of these lumber pieces are rough, and their dimensions may vary slightly from one end to...
Full wave rectifier01:22

Full wave rectifier

A full-wave rectifier is a device that converts alternating current (AC) to direct current (DC) and is more efficient than its half-wave counterpart. It typically includes a center-tapped transformer, two diodes, and a load resistor. The secondary winding of the transformer is divided to provide two equal voltages of opposite polarities, which is the pivotal element of full-wave rectification.
Electro-mechanical Systems01:19

Electro-mechanical Systems

Electromechanical systems are intricate configurations that effectively combine electrical and mechanical elements to achieve a desired outcome. Central to many of these systems is the DC motor, a device that converts electrical energy into mechanical motion, enabling various applications ranging from simple fans to complex robotic mechanisms.
A key component of the DC motor is the armature, a rotating circuit positioned within a magnetic field. As an electric current passes through the...
Wood Surfacing01:14

Wood Surfacing

Wood surfacing is a critical finishing process designed to smoothen the wood surface, enhance its dimensional accuracy, and make handling safer. This process compensates for potential shrinkage during the seasoning phase by marginally increasing the wood dimensions before surfacing. It also helps correct some distortions that may occur as the wood dries.
The equipment used in the surfacing process is a plane equipped with rotating blades. This tool efficiently smoothens the wood surface and can...