Evaluation of arterial endothelial function using transit times of artificially induced pulses

Impairment of arterial endothelial function is an early event in atherosclerosis and correlates with the major risk factors for cardiovascular disease. The most widely employed non-invasive measure of endothelial function involves brachial artery (BA) diameter measurement using ultrasound imaging before and after several minutes of blood flow occlusion. The change in arterial diameter is a measure of flow-mediated vasorelaxation (FMVR). The high between-laboratory variability of results and cost of instrumentation render this technique unsuitable for routine clinical use. We induce artificial pulses at the superficial radial artery using a linear actuator. An ultrasonic Doppler stethoscope detects these pulses 10-30 cm proximal to the point of pulse induction. The delay between pulse application and detection provides the pulse transit time (PTT). By measuring PTT before and after 5 min of BA occlusion and ensuing reactive hyperemia, FMVR may be measured based on the changes in PTT caused by changes in vessel caliber, smooth muscle tone and wall thickness. We (1) validate the sensitivity of this technique to arterial wall tone using sublingual nitroglycerin and (2) compare measurements of endothelial function to ultrasound BA diameter measurements in 12 human subjects. The PTT-based method is verified to measure arterial wall tone and is shown to provide 37% greater sensitivity (p < 0.05) to FMVR than BA diameter measurements. By measuring the change in pulse transit time before and after endothelial stimulus, a sensitive, reproducible and convenient measure of endothelial function may be obtained at a low cost.