Belt-like localisation of caveolin in deep caveolae and its re-distribution after cholesterol depletion

Martin Westermann1, Frank Steiniger, Walter Richter

  • 1Elektronenmikroskopisches Zentrum am Klinikum der Friedrich-Schiller-Universität Jena, Ziegelmühlenweg 1, 07740, Jena, Germany. martin.westermann@uni-jena.de

Related Concept Videos

Frictional Forces on Flat Belts01:28

Frictional Forces on Flat Belts

Flat belts are commonly used in various industrial applications for transmitting power from one pulley to another. When a flat belt is wrapped around a set of pulleys, it experiences different tensions at the driving pulley ends due to the friction between the belt and pulley surface. When the pulley moves in a counterclockwise direction, the tension T2 on the opposite side of the pulley where the belt is moving away from is higher than the tension T1 on the side where the belt is moving...
1.5K
Cholesterol: Significance and Regulation01:29

Cholesterol: Significance and Regulation

Although not a source of energy, cholesterol plays a significant role as a foundational structure for bile salts, steroid hormones, and vitamin D, as well as being a crucial component of plasma membranes. Approximately 15% of blood cholesterol is derived from our diet, with the remainder synthesized from acetyl CoA by the liver and intestines. Cholesterol is eliminated from the body through its conversion into bile salts, which are eventually discarded in the feces.
Considering cholesterol and...
1.5K
Flat Belts: Problem Solving01:28

Flat Belts: Problem Solving

Flat belts are crucial in many industrial applications as they help transmit power from one pulley to another. The concept of forces and moments is used to determine the maximum moment on a pulley. For instance, consider a flat belt that wraps around two pulleys, A and B, with radii of 30 cm and 10 cm, respectively. The angle between the belt and the horizontal is 20 degrees at the pulleys. As pulley B rotates clockwise and drives pulley A, tension T2 is caused at one end of the belt, while...
842
MOSFET: Depletion Mode01:20

MOSFET: Depletion Mode

Depletion-mode MOSFETs represent a unique subset of MOSFET technology, functioning fundamentally differently from their enhancement-mode counterparts. Unlike enhancement MOSFETs, which require a positive gate-source voltage (Vgs) to turn on, depletion-mode MOSFETs are inherently conductive and "normally on" devices.
The primary characteristic of depletion-mode MOSFETs is their ability to conduct current between the drain and source terminals without gate bias. This inherent conductivity...
870
Drug Distribution: Volume of Distribution01:25

Drug Distribution: Volume of Distribution

The volume of distribution refers to the theoretical volume necessary to contain the entire amount of an administered drug at the same concentration observed in the blood plasma. The body's intracellular fluid compartment, which makes up two-thirds of the total body water, is contrasted with the extracellular fluid compartment—comprising plasma and interstitial fluid—that accounts for one-third. The volume of distribution can vary depending on the characteristics of the drug.
7.6K
F Distribution01:19

F Distribution

The F distribution was named after Sir Ronald Fisher, an English statistician. The F statistic is a ratio (a fraction) with two sets of degrees of freedom; one for the numerator and one for the denominator. The F distribution is derived from the Student's t distribution. The values of the F distribution are squares of the corresponding values of the t distribution. One-Way ANOVA expands the t test for comparing more than two groups. The scope of that derivation is beyond the level of this...
10.7K