An autocorrelation model with place dependence to account for the effect of harmonic number on fundamental frequency

Joshua G W Bernstein1, Andrew J Oxenham

  • 1Research Laboratory of Electronics, Massachusetts Institute of Technology, Cambridge, Massachusetts 02139, USA. jgbern@mit.edu

Related Concept Videos

Harmonic Mean01:09

Harmonic Mean

The arithmetic mean is usually skewed towards the larger values in the data set. Therefore, to avoid this inherent bias towards smaller values, the harmonic mean is used.
Take the example of the speed of a car, which is the measure of the rate of distance traveled. If the vehicle traverses the same distance back-and-forth, its average speed equals the total distance traveled divided by the total time taken. However, if the car moves with varying speeds, then the arithmetic mean is more skewed...
Properties of Fourier series II01:21

Properties of Fourier series II

Time scaling of signals is a crucial concept in signal processing that affects the Fourier series representation without altering its coefficients. The process modifies the fundamental frequency, thereby changing how the series represents the signal over time. This principle is essential in various applications, including audio and image processing, where signal manipulation is frequent. Understanding function symmetries is fundamental to simplifying the Fourier series.
A function f(t) is...
Forced Oscillations01:06

Forced Oscillations

When an oscillator is forced with a periodic driving force, the motion may seem chaotic. The motions of such oscillators are known as transients. After the transients die out, the oscillator reaches a steady state, where the motion is periodic, and the displacement is determined.
Properties of Fourier series I01:20

Properties of Fourier series I

The Fourier series is a powerful tool in signal processing and communications, allowing periodic signals to be expressed as sums of sine and cosine functions. A foundational property of the Fourier series is linearity. If we consider two periodic signals, their linear combination results in a new signal whose Fourier coefficients are simply the corresponding linear combinations of the original signals' coefficients. This property is crucial in applications like frequency modulation (FM) radio,...
Determination of Expected Frequency01:08

Determination of Expected Frequency

Suppose one wants to test independence between the two variables of a contingency table. The values in the table constitute the observed frequencies of the dataset. But how does one determine the expected frequency of the dataset? One of the important assumptions is that the two variables are independent, which means the variables do not influence each other. For independent variables, the statistical probability of any event involving both variables is calculated by multiplying the individual...
Modes of Standing Waves - I01:03

Modes of Standing Waves - I

A close look at earthquakes provides evidence for the conditions appropriate for resonance, standing waves, and constructive and destructive interference. A building may vibrate for several seconds with a driving frequency matching the building's natural frequency of vibration; this produces a resonance that results in one building collapsing while the neighboring buildings do not. Often, buildings of a certain height are devastated, while other taller buildings remain intact. This phenomenon...