Related Experiment Video
Updated: Aug 15, 2026
Characterization of Membrane Transporters by Heterologous Expression in E. coli and Production of Membrane Vesicles
Published on: December 31, 2019
The steady-state Michaelis-Menten analysis of P-glycoprotein mediated transport through a confluent cell monolayer
Joe Bentz1, Thuy Thanh Tran, Joseph W Polli
1Department of Bioscience and Biotechnology, Drexel University, Philadelphia, Pennsylvania, 19104, USA. bentzj@drexel.edu
Purpose:
Typically, the kinetics of membrane transport is analyzed using the steady-state Michaelis-Menten (or Eadie-Hofstee or Hanes) equations. This approach has been successful when the substrate is picked up from the aqueous phase, like a water-soluble enzyme, for which the Michaelis-Menten steady-state analysis was developed. For membrane transporters whose substrate resides in the lipid bilayer of the plasma membrane, like P-glycoprotein (P-gp), there has been no validation of the accuracy of the steady-state analysis because the elementary rate constants for transport were not known.
Methods:
Recently, we fitted the mass action elementary kinetic rate constants of P-gp transport of three different drugs through a confluent monolayer of MDCKII-hMDR1 cells. With these elementary rate constants in hand, we use computer simulations to assess the accuracy of the steady-state Michaelis-Menten parameters. This limits the simulation to parameter ranges known to be physiologically relevant.
Results:
Using over 2,300 different vectors of initial elementary parameters spanning the space bounded by the three drugs, which defines 2,300 "virtual substrates", the concentrations of substrate transported were calculated and fitted to Eadie-Hofstee plots. Acceptable plots were obtained for 1,338 cases.
Conclusion:
The fitted steady-state Vmax values from the analysis correlated to within a factor of 2-3 with the values predicted from the elementary parameters. However, the fitted Km value could be generated by a wide range of underlying "molecular" Km values. This is because of the convolution of the drug passive permeability kinetics into the fitted Km. This implies that Km values measured in simpler systems, e.g., microsomes or proteoliposomes, even if accurate, would not predict the Km values for the confluent monolayer system or, by logical extension, in vivo. Reliable in vitro-in vivo extrapolation seems to require using the elementary rate constants rather than the Michaelis-Menten steady-state parameters.
Related Concept Videos
01:18Nonlinear Pharmacokinetics: Michaelis-Menten Equation
Vmax represents the maximum achievable process rate, while KM, known as the Michaelis constant, signifies the drug concentration at which the process rate reaches half its maximum. This relationship between Vmax, KM, and Cp gives rise to three distinct...
01:20Determination of Michaelis Constant and Maximum Elimination Rate
These parameters can be estimated by analyzing plasma concentration data post-drug administration. A notable example of this application is phenytoin, a drug with capacity-limited kinetics. It's recommended that phenytoin should be administered at two...
01:19Introduction to Enzyme Kinetics
The experimenter can then plot the initial reaction rate or velocity (Vo) of a given trial against the substrate concentration ([S]) to obtain a graph of the reaction properties. For many enzymatic reactions involving a...
01:19Enzyme Kinetics
Scientists typically study enzyme kinetics with a fixed amount of enzyme in the controlled environment of a test tube. When more reactant, or substrate, is...
01:24One-Compartment Open Model: Wagner-Nelson and Loo Riegelman Method for ka Estimation
On...
01:15Determination of Multiple Dosing Parameters: Steady-State, Minimum and Maximum Concentrations