Optimal wet corn gluten and protein levels in steam-flaked corn-based finishing diets for steer calves

A feeding trial evaluated the hypothesis that wet corn gluten feed would improve growth performance of cattle fed steam-flaked corn-based finishing diets and supply required degradable intake protein (DIP). The trial used 360 steer calves (initial BW = 288 +/- 11 kg) housed in 36 pens for 166 d in an incomplete 4 x 3 factorial arrangement of treatments. Pens of steers were assigned to treatments according to a completely randomized design (four replicates per treatment combination). Treatments were wet corn gluten feed (0, 20, 30, or 40% of dietary DM) and CP (13.0, 13.7, or 14.4% of dietary DM) via supplemental urea as DIP. The 0% wet corn gluten feed treatment included only the 13.7% CP diet, and the 40% wet corn gluten feed treatment included only the 13.7 and 14.4% CP diets. Final dietary DIP concentration was 9.0% for 0% wet corn gluten feed; 8.7, 9.5, and 10.2% for 20% wet corn gluten feed; 9.0, 9.7, and 10.3% DIP for 30% wet corn gluten feed; and 10.0 and 10.6% for 40% wet corn gluten feed. Hot carcass weight, ADG, DMI, and G:F responded quadratically (P < or = 0.05) to wet corn gluten feed. The 20, 30, and 40% wet corn gluten feed treatments increased ADG by 7, 6, and 3% and increased DMI by 4, 5, and 5%, respectively, relative to the 0% wet corn gluten feed treatment. Feed efficiency was 102, 101, and 98% of the 0% wet corn gluten feed treatment for 20, 30, and 40% wet corn gluten feed, respectively. Hot carcass weight, ADG, and G:F increased linearly (P < or = 0.05) in response to increased DIP. Nonlinear analysis for DIP over the combined 20 and 30% wet corn gluten feed treatments indicated a DIP requirement of 9.6% of DM for ADG and 9.2% of DM for G:F, corresponding to 14.6 and 14.3% CP for 20% wet corn gluten feed and 14.8 and 14.5% CP for 30% wet corn gluten feed, respectively. Fat thickness, marbling, LM area, and USDA yield grade were not affected (P = 0.12 to 0.99) by wet corn gluten feed or CP. These results show that the inclusion rate of wet corn gluten feed for maximizing ADG and G:F in steam-flaked corn-based finishing diets is approximately 20% of DM. The DIP requirement determined in this trial averaged 9.4% of DM.